Overview
The Rubicon Express JT7140E is a 2.5/3.5 inch Super-Flex suspension lift kit with shock extensions for the 2020–2026 Jeep Gladiator JT. It is a direct fit for the Gladiator trims covered by this kit.
The kit is a short arm system with coil springs at the rear, and the lift height range is 0 to 3.5 inches. The specifications list a 35-inch tire size, and they mark the shocks as included with no front shock named.
The system keeps the factory mounting locations and adds new adjustable control arms and spherical ball joints. The kit includes front sway bar disconnects, a forged front adjustable track bar, replacement coil springs and extended bump stops.
Key features
- New adjustable upper and lower control arms at the front and rear
- Serviceable Super-Flex spherical ball joints
- Front sway bar disconnects and a forged front adjustable track bar
- Twin tube shocks are included.
- Replacement coil springs and extended bump stops
Adjustable arms and ball joints
Control arms locate the axle and hold the front wheels in position, so adjustable arms let an installer set caster and alignment rather than accepting factory settings. Spherical ball joints allow the arm to move through a wider range of angles, which helps when the suspension cycles over rough ground. Ball joints wear over time, and serviceable joints can be greased and replaced without replacing the whole arm.
After a short arm install, check the steering components for play, and inspect the track bar and sway bar disconnect hardware after the first few drives. A forged track bar can still wear at its bushings, so listen for clunks over bumps. Re-check the alignment after any change to the front geometry, and keep the bump stops and coil springs under inspection as the truck ages.
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | R/EJT7140E (JT7140E) |
| Kit type | Super-Flex short arm suspension lift kit |
| Lift height range | 0 to 3.5 inches |
| Tire size | 35 inches |
| Rear lift method | Coil springs |
| Rear lift component | Coil spring |
| Front shocks | None listed |
| Shocks included | Yes |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2020–2026 Jeep Gladiator JT in the 80th Anniversary, Altitude, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport trims.
Wrangler models and Gladiator years outside 2020–2026 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
New control arms, spherical ball joints and a forged track bar change the front geometry, so a full alignment should follow the install. Check the shock length after the lift is set.
What’s included
The kit includes the control arms, ball joints, sway bar disconnects, track bar, coil springs, extended bump stops and the shock extensions. Twin tube shocks are included.

















