Overview
The Rough Country 3.5-inch Jeep lift kit, part number R/C60200, is a direct fit kit for the 2020–2026 Jeep Gladiator, including the Mojave, Rubicon, Overland, Sport and Willys versions. It uses front and rear coil springs to lift the truck and is listed to provide enough ground clearance for tires up to 37 inches.
The coil springs are heavy duty. The kit is built to keep the ride close to factory while adding clearance for trail use or daily driving. The factory shocks are reused, so the kit does not include shock absorbers.
Heavy-duty coil springs carry more load than standard springs, and a lift of this size changes ride height by replacing the spring height and rate together. Because the springs are heavy duty, check the rated load before carrying a heavy bed load or a trailer.
The kit’s lift range is 0 to 3.5 inches, and the 3.5-inch size is the stage 1 lift.
Key features
- Heavy-duty front and rear coil springs
- Ground clearance for tires up to 37 inches
- Ride quality close to factory
- 100% bolt-on installation with no fuss assembly
- Lifetime replacement warranty
- Listed lift height range of 0 to 3.5 inches
Load rating and trailering
Trail and daily-driven trucks put different demands on springs. A heavier front or rear load compresses the coils and can shorten their useful life, so match the spring rating to the payload. A Gladiator with a camper shell, roof rack or bed rack carries extra weight that the stock setup did not plan for, and that weight should be counted before adding a lift.
Tire size matters too. Larger tires change the load path into the wheel bearings and axle. Check bearing preload, wheel bearing seals and brake hose length after installation, and retighten the lug nuts after the first short drive. Lifted trucks also benefit from a steering damper check during regular inspections.
- Weigh the bed and cargo before a trip
- Inspect wheel bearings after the first off-road outing
- Check brake hose length at full droop
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C60200 |
| Lift kit | 3.5 inches, stage 1 |
| Rear lift method | Coil springs |
| Rear lift component | Coil spring |
| Front shocks | Reuse factory shocks |
| Rear shocks | Reuse factory shocks |
| Shocks included | No |
| Tire size | 37 inches |
| Lift height range | 0 to 3.5 inches |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2020–2026 Jeep Gladiator, including the 80th Anniversary, Altitude, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport versions.
The Wrangler (JL) and the Gladiator years before 2020 are not on the list. Other Jeep models are not covered.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the lift changes ride height and suspension geometry, have the alignment checked after installation and check the driveline angles on a lifted Gladiator.
What’s included
Front and rear coil springs and the bolt-on hardware.
Not included: shock absorbers, since the factory shocks are reused.













