Overview
The RockJock RJ-150000-101 is a complete set of eight Johnny Joint adjustable length control arms for the ’20 & up Jeep JT Gladiator, which covers the 2020–2026 model years. RockJock sells the set as a full replacement for the Gladiator’s control arm positions.
All of the arms are built from heavy tubular steel. Johnny Joint rod ends are used at both ends of most arms, with one exception: the axle end of the front upper arms does not use a rod end. All four rear arms are double adjustable, with a threaded Johnny Joint on both ends.
The Johnny Joint rod ends offer 30 degrees of overall travel. The joints are urethane bushed, greasable and fully rebuildable, so the arms can be serviced rather than replaced when the joints wear.
Key features
- Complete set of eight adjustable length arms
- Heavy tubular steel construction
- Johnny Joint rod ends, 30 degrees of overall travel
- Four rear arms that are double adjustable
- Urethane bushed joints
- Greasable and fully rebuildable joints
Setting arm length after install
Adjustable control arms change caster, pinion angle and axle position, so each arm length affects how the vehicle tracks and how the driveline works. Set the arms to the lengths your build needs, and keep the adjustment even on both sides where the setup calls for it. Once the set is in, have the alignment and driveline angles measured before the vehicle sees far use.
Johnny Joint ends work through a range of motion, and their travel limits matter when the suspension articulates. Check the joints for play after the first few trail runs and grease them as routine maintenance. Keep the threads clean on the threaded rear arms so the jam nuts hold their setting.
- Grease joints regularly, especially after water or mud exposure
- Recheck jam nut tightness after each adjustment
- Record arm lengths for future alignment work
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | RJ-150000-101 |
| Quantity | Set of 8 arms |
| Construction | Heavy tubular steel |
| Joint travel | 30 degrees overall |
| Joint bushing | Urethane |
| Rear arms | Four, double adjustable with Johnny Joint ends on both ends |
Vehicle fitment
The set is for the ’20 & up Jeep JT Gladiator, which covers the 2020–2026 model years. It is a complete replacement for the Gladiator’s control arm positions.
The set is built for the Gladiator JT. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Adjustable arms change caster, pinion angle and axle position, so set the lengths carefully and have the alignment and driveline angles checked after the set is installed.
What’s included
A complete set of eight Johnny Joint adjustable length control arms, including four rear arms that are double adjustable.







