Overview
The RockJock 4×4 CE-9114BLR is a custom machined, weld-in threaded bung with a 1 1/4 inch -12 left hand thread. It is built for forged Johnny Joint rod ends or any other 1 1/4 inch thread rod end, and it fits a tube with a 1 1/2 inch inside diameter. Jam nut not included.
Part number R/JCE-9114BLR identifies this left hand version, sold as one bung per unit.
Key features
- Custom machined weld-in design
- Left hand thread, 1 1/4 inch -12
- Minimum tube inside diameter of 1 1/2 inch
- Built for Johnny Joint rod ends and other 1 1/4 inch thread rod ends
Preparing the tube for welding
A weld-in bung depends on a clean, properly fitted tube, so prepare the bore and mounting area before striking an arc. Remove paint, rust and mill scale from the area where the bung sits. Check that the bung seats square in the tube and that the threaded end is fully clear of weld spatter. Thread protection during welding keeps the internal threads usable afterward.
Take time to plan the rod end and jam nut before welding. Install the rod end on the bung temporarily to confirm the length and clearance you need. Left hand threads reverse how the rod end adjusts, so mark the orientation clearly. Once the weld cools, check the threads again and clean any residue. A bung that was welded out of square often binds the rod end, so correct alignment early.
- Clean the mounting area to bare metal
- Confirm the thread direction before welding
- Protect the internal threads from spatter
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JCE-9114BLR |
| Thread size | 1 1/4 inch -12 |
| Thread direction | Left hand |
| Minimum tube inside diameter | 1 1/2 inch |
| Jam nut included | No |
| Unit | Each |
| Fitment | Universal fit |
Vehicle fitment
Its fitment is universal, and it is not tied to one car.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a weld-in bung, so it is welded into the tube rather than bolted on. A qualified welder should complete the weld, because the bung takes load through the rod end. Add a left hand jam nut, which is not included.
What’s included
One weld-in bung.
Not included: the jam nut and the rod end.









