Overview
The Rock Krawler RK06727 is a front stackable bump stop set for the 2018–2019 Jeep Wrangler JL, in both 2-door and 4-door bodies. It includes eight 1 inch interlocking pucks, which stack to set the front bump stop height from 1 to 4 inch.
The set is a direct fit for the JL trims covered under Vehicle fitment. It is made in the USA.
Key features
- Eight 1 inch interlocking pucks
- Stackable to a 1 to 4 inch range
- Front position
- Made in the USA
- Direct fit to the listed JL trims
Front stop and suspension check
Front bump stops limit how far the front axle can compress, which protects the shocks and steering components at the end of travel. Stacked pucks are a simple way to raise the stop height in steps, but each added piece moves the engagement point closer to the suspension. Check the setting after every change so the stop is reached at the intended height.
Because the front axle carries steering and brake lines, stop changes can affect more than ride height. Look for contact between the axle, brake hoses and steering linkage at full compression. Keep the pucks clean and dry, and replace any that crack or lose their shape after hard use.
- Count the pucks used before and after each change
- Check brake hose routing at full compression
- Inspect pucks for cracks or flattening
- Retighten hardware after the first few drives
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RKSRK06727 |
| Pucks | Eight 1 inch interlocking pucks |
| Adjustment range | 1 to 4 inch |
| Position | Front |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2018–2019 Jeep Wrangler JL in its Rubicon, Sport and Sport S 2-door trims, and in its Unlimited Rubicon, Unlimited Sahara, Unlimited Sport and Unlimited Sport S 4-door trims.
The Wrangler JK and the Wrangler JL 2020 and later are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The pucks stack, so the front stop height is set by the number of pucks used. The stop should be checked for clearance at full compression after the install, and the front suspension should be checked for correct engagement.








