Overview
The Rock Krawler RK06726 is a rear bump stop set for the 2018–2019 Jeep Wrangler JL. The set is built from six 1 inch interlocking pucks and two fabricated 1 inch blocks, which together set the rear bump stop height from 1 to 4 inch.
The brackets and tabs are laser cut and precision welded for heavy construction. Hardware for the installation is included.
Key features
- Six 1 inch interlocking pucks
- Two fabricated 1 inch blocks
- Hardware included
- Laser cut and precision welded brackets and tabs
- Heavy construction, per the manufacturer
Checking stop clearance
Bump stops limit how far the suspension can compress, so they take the load when the axle reaches the end of its travel. Over time the material can flatten, split or loosen at the mounting points, especially on vehicles that see hard off-road use. Check the stops for cracks and movement every time the suspension is serviced.
Stacking pucks or blocks changes when the stop engages. The suspension can reach the stop sooner, which affects shock length, brake line length and driveshaft angle. Recheck those items after any change to stop height, and confirm the vehicle still has full travel without binding.
- Look for cracked or flattened pucks
- Recheck clearance at full compression after any change
- Tighten mounting hardware after the first few trail runs
- Inspect brake lines and shocks for stretch or rub
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RKSRK06726 |
| Type | Fabricated block |
| Pucks | Six 1 inch interlocking pucks |
| Blocks | Two fabricated 1 inch blocks |
| Position | Rear |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2018–2019 Jeep Wrangler JL in its Rubicon, Sport and Sport S 2-door trims, and in its Unlimited Rubicon, Unlimited Sahara, Unlimited Sport and Unlimited Sport S 4-door trims.
The 2020 and later Wrangler JL and the Wrangler JK are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The set is built from pucks and blocks, so the stop height is set by how many pieces are stacked. Hardware is included, and the stop should be checked for clearance at full compression after the install.








