Overview
The Rigid Industries Adapt XP LED light (part number RIG300415) is an off-road LED light with an adaptive design. It is a universal fit light and is not built for one vehicle. It has a high-strength aluminum heat sink and an impact-resistant polycarbonate lens.
The Adapt XP adapts in two ways. The first layer is Rigid’s Active Power Management system, which monitors input voltage. When voltage is stable, the light uses all available power. When voltage drops, Active Power Management gradually reduces the light’s power draw until the vehicle’s voltage steadies.
The second layer is Active View Technology. An internal GPS module reads the vehicle’s speed and routes power among three optic zones: scene optics at low speed, driving optics at moderate speed and spot optics at high speed. Power moves between zones gradually, which Rigid says gives a smoother transition and reduces eye fatigue.
The magnetic reed power clip changes the light’s output and draw. With the clip in place, output is 40 watts and a single light draws up to 2.7 amps, while a pair draws up to 2.5 amps per light, with all zones active. With the clip removed, a single light draws up to 6.5 amps for 90 watts of output, and a pair draws up to 5.7 amps per light for 80 watts.
Key features
- Active Power Management monitors input voltage and adjusts power draw
- Active View Technology routes power to scene, driving or spot optics by vehicle speed
- Internal GPS module reads vehicle speed
- Magnetic reed power clip that changes output and draw
- High-strength aluminum heat sink
- Impact-resistant polycarbonate lens
- Available as a single light or a pair
Power draw and wiring
Adaptive LED lights are easy to overload when several are run together on a single circuit. Before wiring, add up the draw of every light, the relay, the switch and the fuse, then confirm the vehicle’s charging system and battery can support the total. A correctly sized relay keeps the load off the switch, and a fuse close to the battery protects the wiring if a fault occurs.
Route the harness away from heat, sharp edges and moving suspension parts, and use weatherproof connectors where the wire passes through the body. Recheck the mounts and connectors after the first few trips, because vibration can loosen connections over time. Keep the lens clean so the output stays evenly distributed.
- Total the draw of all lights before wiring
- Use a relay and a fuse close to the battery
- Route the harness away from heat and suspension
- Recheck connectors after the first trips
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | RIG300415 |
| Light type | LED |
| Heat sink | High-strength aluminum |
| Lens | Impact-resistant polycarbonate |
| Optic zones | Three: scene, driving and spot |
| Power clip in place | Single light up to 2.7 amps; pair up to 2.5 amps per light; output 40 watts |
| Power clip removed | Single light up to 6.5 amps, 90 watts output; pair up to 5.7 amps per light, 80 watts output |
Vehicle fitment
It is a universal fit light, so plan the mounting location and wiring for your own vehicle. Check that its electrical system can handle the power draw of the setup you choose. Confirm your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Wire the light with a fused relay and the harness that matches your setup, and check local rules before running auxiliary lights on public roads. Removing the power clip raises both draw and output, so check the electrical load before removing it.
What’s included
One Rigid Industries Adapt XP LED light, part number RIG300415.
Not included: the wire harness and switch, which Rigid sells separately. Use harness #36360 for a pair of lights and harness #40187 for a single light.









