Overview
The Rigid Industries ADAPT 30 Inch LED Light Bar (part 230413) is a flood and driving light bar with eight selectable beam patterns. It runs at 248 watts with a 36 volt maximum input. Its patterns range from a 90 degree broad, short distance beam to a focused 15 degree long distance spot, all in one fixture.
The ADAPT uses Active View Technology to adjust the beam pattern as vehicle speed changes. The bar has no moving parts and changes its output through advanced LEDs and patented optics. Built-in accent lighting can be set to any color, including white. It supports base mounting as well as side mounts. The ADAPT is available in lengths from 10 to 50 inches, and this 30 inch version is rated at 248 watts.
Key features
- Eight selectable beam patterns, from 90 degree broad to 15 degree spot
- Active View Technology
- No moving parts in the optics
- Built-in accent lighting in any color, including white
- Base mounting and side mounting options
- Dash Controller for beam and accent control
- Programmable presets and Adaptive Mode
Wiring and dash control
An adaptive light bar works differently from a fixed one, because the beam pattern changes from the controller rather than from a single switch. Plan the controller location before running the wire, and keep it where the driver can reach it without taking eyes off the road. A clean, secure mount keeps the controls from moving over rough ground.
The draw of a bar this size needs a fused feed sized for the full load, and a relay helps keep the switch and controller circuit clean. Check the harness at its connectors and at every clip after the first few trail runs, since vibration can loosen plugs and cause intermittent changes in the beam. Accent lighting shares the same wiring, so include it in the total load.
- Confirm the total load before choosing the fuse
- Route the wire away from the steering shaft and pedals
- Re-check connectors after rough trail use
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 230413 |
| Light type | LED light bar |
| Size | 30 inch |
| Beam pattern | Flood/driving, eight selectable patterns |
| Power | 248 watts |
| Voltage max | 36 |
| Finish | Black |
| Mounting | Surface, side or base mounts |
| Included | Dash Controller, Under Dash Module, wiring harness, mounting hardware |
| Sold as | Single |
Vehicle fitment
The ADAPT is a universal fit bar, not built for one vehicle. Confirm the mounting location and the clearance for a 30 inch bar before drilling.
Installation notes
The kit includes the Dash Controller, an Under Dash Module, a wiring harness and mounting hardware. Plan the dash controller location and the wire route before installation. Fuse the feed for the 248 watt load, and check local rules for auxiliary lighting on public roads.
What’s included
The ADAPT 30 inch light bar, a Dash Controller, an Under Dash Module, a wiring harness and mounting hardware.











