Overview
The Revtek 437 is a lift kit for the Toyota Tundra 4WD that raises the front 2.5 inches and the rear 1.5 inches for a level ride height. It is designed for 2007–2008 Tundra 4WD models and fits 2007–2017 Tundra models.
The kit is made from CNC-machined billet aluminum components. It installs with no drilling or welding, and it does not require replacement shocks, so the existing shock absorbers can stay in place.
Key features
- Front lift of 2.5 inches and rear lift of 1.5 inches
- CNC-machined billet aluminum components
- No drilling or welding for installation
- Coil spacers at the front
- U-bolt kit and hardware kit included
- Replacement shocks not required
Before you install
A front and rear lift that differ in height changes how the axles sit relative to the driveline, so a level result is worth checking with a tape measure on both sides of the truck before and after the install. Rear lift blocks and add-a-leaf setups raise the axle and can stretch the brake lines and parking brake cable, so inspect those lines once the truck is at its new height. Steering and track bar geometry can also shift a little, which is why alignment is part of the job.
U-bolts can loosen as the leaf pack settles, so tighten them again after the first few drives and inspect them at routine service intervals. Worn ball joints, tie rod ends and track bar bushings are often replaced while the front is apart, which keeps the new geometry tight. Keep the stock shocks in good condition, because they will be working at a new angle after the lift.
Specifications
| Brand | Revtek |
|---|---|
| Part number | 437 |
| UPC | 811323010177 |
| Lift height | 2.5 inch front, 1.5 inch rear |
| Suspension type | Spacer |
| Front lift | Coil spacers |
| Rear lift method | Lift block, U-bolts and add-a-leaf |
| Component material | CNC-machined billet aluminum |
| Shocks | Not included; replacement not required |
Vehicle fitment
The kit fits 2007–2017 Toyota Tundra models, including 1794 Edition, Base, Limited, Platinum, SR and SR5 trims.
Tundra model years outside 2007–2017 fall outside this fit. The kit is designed for 4WD trucks, so check the drivetrain against your truck before ordering.
Installation notes
Because the kit installs with no drilling or welding, it is a bolt-on job at both ends. The rear uses lift blocks with U-bolts and add-a-leaf, so check the rear lift and the alignment after installation.
What’s included
The kit includes coil spacers, a U-bolt kit and a hardware kit, with the rear lift blocks and add-a-leaf listed in the specifications.
Not included: Replacement shocks, which are not required.









