Overview
The Rancho RS999070 is a rear RS9000XL shock for the 2020 Jeep Gladiator, sold individually and designed for a 2-inch lift.
The RS9000XL is Rancho’s nine-position adjustable series. This shock has a 2.75-inch (70 mm) tri-tube body and an 18 mm nitro-carburized rod, and its damping can be changed with a nine-position adjustment knob. The adjustable damping helps control the extra unsprung mass of larger tire and wheel combinations.
Some sizes vary by application. The series is engineered and manufactured in the U.S. The lower mount is a loop bushing and sleeve mount with a 14 mm sleeve inside diameter, and the upper mount uses a 14 mm sleeve inside diameter with a 39.69 mm sleeve length.
Key features
- Rear shock for a 2-inch lift
- Nine-position tuning with adjustment knob
- Gas pressurized body
- Graphite-filled, Fluon banded piston
- 1-1/4-inch sintered iron piston
- Rebound bumper and low-friction, self-lubricating seal
- Liquid metallic finish, protective boot and double-welded loops
Matching a rear shock to lift
Rear shocks do most of their work when the axle is compressed over bumps and when it rebounds after a drop. On a lifted Gladiator, the longer suspension travel and the heavier wheel and tire packages change how the shock behaves, so the damping setting matters more than it does on a stock truck. A nine-position adjuster gives room to match firmness to a light trail rig or a heavier setup used for towing or rock crawling. Start in a middle setting and adjust in small steps, noting how the rear end settles on washboard and pavement.
Shocks wear out gradually. Look for fluid leaking past the seal, a boot that is torn or cracked, bushings that have gone loose, and a rear end that bounces longer than usual after a bump. Because the sleeve mounts sit at both ends, inspect the bushings and sleeves whenever the shock comes off. Replacing rear shocks in pairs keeps the damping even from side to side.
Specifications
| Brand | Rancho |
|---|---|
| Part number | RANRS999070 |
| Series | RS9000XL |
| Position | Rear |
| Lift | 2 inch |
| Body | 2.75-inch (70 mm) tri-tube |
| Rod | 18 mm nitro-carburized |
| Compressed length | 19.76 inches |
| Extended length | 28.22 inches |
| Travel | 8.46 inches |
| Lower mount | Loop bushing and sleeve, 14 mm sleeve ID by 1-9/16-inch sleeve length |
| Upper mount | Loop bushing and sleeve, 14 mm sleeve ID by 39.69 mm sleeve length |
Vehicle fitment
It fits the 2020 Jeep Gladiator in the Launch Edition, Mojave, Overland, Rubicon, Sport and Sport S versions.
The list does not include the Wrangler JL or Gladiator model years other than 2020. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the sleeve sizes at each mount against the old shock before installing, since some sizes vary by application. Lower and upper mount sizes are separate, so measure both before ordering.
What’s included
The shock is sold individually. It includes a protective boot, double-welded loops and a liquid metallic finish.









