Overview
The Rancho RS55040 is a rear RS5000X monotube shock for the 2000 through 2006 Toyota Tundra 4WD models. It has no lift and is built for a stock-height truck.
The shock has a 2.25-inch twin tube body, a 1.375-inch sintered iron piston and a 16 mm nitro-carburized rod. The Fluon banded piston is glass-filled, and the seal is low-friction and self-lubricating. Each unit is sold individually.
Rancho says its Tuned Compression Control Valve is part of the design, which together with the polyurethane rebound bumper is meant to control the shock through harsh driving.
The 35 mm bore is full-displaced, and the low-friction, self-lubricating seal is part of the same build. The shock is made for 4WD models, so it is not the right fit for 2WD trucks. Check the drive type and factory ride height before ordering this rear shock.
Confirm the drive type and factory ride height before ordering this rear shock.
Key features
- Rear monotube shock absorber, no lift
- Tuned compression control valve
- Full-displaced 35 mm bore
- Polyurethane rebound bumper
- Low-friction, self-lubricating seal
- Protective red boot for the rod and oil seal
- Limited lifetime warranty
Rear shock care and checks
Rear shocks on a body-on-frame pickup control the axle as it rises and falls over bumps, and they help keep the tires planted under braking. Over time, worn dampers allow the rear to bounce after dips and can make the truck feel loose at highway speed. Uneven tire wear and oil on the shock body are also common signs of a tired unit.
When replacing a rear shock, check the other side as well, since mismatched damping can make the back end feel uneven. Inspect the eye bushings and mounting hardware while the old shock is off. Recheck the fasteners after the first few drives, and keep the boot in place to protect the rod from grit.
- Look for oil streaks on the shock body
- Check the eye bushings for cracks or wear
- Replace the boot if it is torn
Specifications
| Brand | Rancho |
|---|---|
| Part number | RANRS55040 |
| Series | RS5000X |
| Position | Rear |
| Shock type | Monotube |
| Lift | No lift |
| Body | 2.25-inch twin tube |
| Piston | 1.375-inch sintered iron |
| Rod | 16 mm nitro-carburized |
Vehicle fitment
It fits the 2000 through 2006 Toyota Tundra in 4WD models. Tacoma models and Tundra years after 2006 are not covered. Verify your vehicle’s year, model and trim before ordering.
The list does not include the Tacoma or any Tundra model years after 2006. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The shock comes with its protective red boot and is sold individually.











