Overview
The Rancho RS55375 is a front RS5000X monotube shock for the 2004 through 2012 Chevrolet Colorado and the 2004 through 2012 GMC Canyon. It is built for torsion bar front suspension and has no lift.
The RS5000X uses a patented rebound valving system and an advanced compression phase. This unit has a 2.25-inch twin tube body, a 1.375-inch sintered iron piston and a 16 mm nitro-carburized rod, with a polyurethane rebound bumper that controls rebound in harsh driving.
Black natural rubber bushings absorb some ride harshness, and double-welded loops add strength. A red boot covers the rod and oil seal during on and off-road driving.
Because the shock is for torsion bar front suspension, confirm that your Colorado or Canyon has that setup before ordering. Compare the 2.25-inch body and the 16 mm rod with the unit you remove.
Key features
- Front monotube shock absorber with no lift
- Tuned compression control valve
- Full-displaced 35 mm bore
- Polyurethane rebound bumper for harsh driving
- Low-friction, self-lubricating seal
- Protective red boot for the rod and oil seal
- Limited lifetime warranty
Front suspension setup notes
Torsion bar front suspension uses bars rather than coil springs to carry the front end, so the shock’s job is mainly damping the movement of the control arms and body. Because the spring rate is set by the bar, a worn shock often shows up as a loose or wandering front end rather than a sag. Worn shocks can also cause the tires to scallop.
When replacing a front shock, keep the factory mounting position. Aftermarket spacers and relocation brackets change the geometry the shock was built for, which can alter damping and stress the mounts. Inspect the upper mount, the bushings and the boot while the old unit is off. Front shocks are often replaced in pairs so both sides damp the same way.
- Check the upper and lower mounts for cracks or play
- Look for oil on the body or a torn boot
- Confirm steering feel and tire wear after installation
Specifications
| Brand | Rancho |
|---|---|
| Part number | RANRS55375 |
| Series | RS5000X |
| Position | Front |
| Shock type | Monotube |
| Body | 2.25-inch twin tube |
| Piston | 1.375-inch sintered iron, Fluon banded |
| Rod | 16 mm nitro-carburized |
| Bore | 35 mm, full-displaced |
| Sold as | Individually |
Vehicle fitment
It fits the 2004 through 2012 Chevrolet Colorado and the 2004 through 2012 GMC Canyon. Other Chevrolet or GMC trucks and model years outside 2004 through 2012 are not covered. Confirm the year, model and trim of your vehicle before placing an order.
The list does not include other Chevrolet or GMC trucks, or model years outside 2004 through 2012. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This shock is for torsion bar front suspension. Do not install it with aftermarket shock spacers or relocation brackets.
What’s included
The shock is sold individually, with its protective red boot.











