Overview
The Pro Comp ZX2082 is a rear Pro Runner monotube shock absorber for late-model trucks, Jeeps and SUVs. It has a gas charged monotube body with a 2 inch diameter, and its valving is tuned to each application rather than set to one general-purpose ride. It is rated for 0 to 1 inch of lift.
A monotube uses a single tube with a gas-charged piston, unlike a twin tube shock with an inner pressure tube and an outer reserve tube. The nitrogen charge keeps oil from foaming during compression and rebound, which reduces cavitation and helps the shock shed heat. That supports less fade on long towing trips or fast desert whoops.
Key features
- Monotube body, gas charged with nitrogen to limit cavitation during compression and rebound
- Multi-stage valving that Pro Comp says is tuned to each application
- Brushed zinc plated body with a clear coat finish
- Rubber bushing included
- Black polyurethane shock boots included
- Backed by a 90-day ride guarantee.
- Lifetime warranty that Pro Comp describes as 100% transferable
Monotube vs. twin tube
A twin tube shock uses an inner pressure tube and an outer reserve tube, while a monotube keeps oil and gas in one tube separated by a piston. Monotube designs are often chosen for steadier damping when the shock runs hot, such as on long grades or fast desert sections. Compare how the vehicle will be driven before choosing between them.
Rear shocks should be matched in pairs, and the bushings at each end should be checked when the old shock comes off. Rubber bushings wear and crack with age and can make a shock clunk. Keep the boots clean and undamaged so grit does not score the shaft, and inspect the shock after rough trail use. Replacing both sides together keeps handling even.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | ZX2082 |
| UPC | 614901094862 |
| Shock series | Pro Runner |
| Mounting location | Rear |
| Shock type | Monotube, gas charged with nitrogen |
| Body diameter | 2 inch |
| Finish | Brushed zinc plated with clear coat |
| Lift range | 0 to 1 inch of lift |
| Bushing | Rubber bushing included |
| Boots | Black polyurethane shock boots included |
| Warranty | 90-day ride guarantee; lifetime warranty, 100% transferable |
Vehicle fitment
It is a direct fit for the 2000 to 2006 Toyota Tundra. Other Tundra years and other Toyota trucks are outside this fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pro Comp rates this shock for 0 to 1 inch of lift. If your truck has more lift than that, confirm the shock’s length and mounting points against your suspension before installing it.
What’s included
A rubber bushing and black polyurethane shock boots are included with the shock.

























