Overview
The Pro Comp Pro Runner ZX2021 is a rear gas-charged monotube shock absorber with loop-style upper and lower mounts. It fits a 0 to 1.5 inch lift and measures 29.76 inches extended, 18.32 inches collapsed and 11.44 inches of travel.
The monotube design, nitrogen charge and multi-stage valving were tuned for late-model trucks and SUVs through dyno and real-world testing. The zinc plated, clear coated body is nitrogen charged to reduce cavitation during compression and rebound, which helps the shock shed heat.
A monotube body uses one pressure tube, so the piston and the gas section work inside the same housing. That layout differs from the inner and outer tubes of a twin-tube shock, and it is the reason for the gas charge described above.
The 0 to 1.5 inch lift range and the loop mounts at both ends are the two details to confirm on the truck before fitting.
Key features
- Rear placement with loop upper and lower mounts
- Monotube body with a nitrogen charge
- Multi-stage valving tuned for the application
- Zinc plated, clear coated finish
- Boot included
Choosing the right setup
A rear shock controls how the axle moves over bumps and under braking, so its damping should suit the load the truck carries. On a heavy-duty pickup used for towing or hauling, the shock works harder than it would on a lightly loaded daily driver. The nitrogen charge helps keep damping steady when the oil heats up during repeated hard compression.
Monotube shocks like this one run a single pressure tube, which resists foaming under sustained use better than many older designs. Before choosing a replacement, consider the lift height you run, how the truck is used and whether the mounts match the shock you remove. Rear shocks are often replaced in pairs so both sides damp evenly.
- Replace rear shocks in pairs for even damping
- Check bushings and mount hardware when fitting
- Inspect the boot for cracks or tears
- Look for fluid streaks along the body
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | ZX2021 |
| UPC | 614901024234 |
| Shock series | Pro Runner |
| Position | Rear |
| Lift height | 0 to 1.5 in. |
| Extended length | 29.76 in. |
| Collapsed length | 18.32 in. |
| Travel | 11.44 in. |
| Upper and lower mounts | Loop |
| Adjustable | No |
| Finish | Zinc plated, clear coated |
| Boot included | Yes |
Vehicle fitment
It fits the 2005–2016 Ford F-250 Super Duty and the 2005–2016 Ford F-350 Super Duty.
Super Duty years outside 2005–2016, and F-150 models, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the shock being replaced, since this rear unit covers a 0 to 1.5 inch lift range, and confirm the loop mounts against your truck.
What’s included
One rear monotube shock, with its boot.






























