Overview
The Pro Comp Suspension PR2129 is a PRO-M front monotube shock for 2017 to 2021 Ford F-250 and F-350 Super Duty trucks with a 3.5 inch lift. It has an extended length of 24.6 inches and a collapsed length of 16.2 inches.
The shock is nitrogen gas charged and uses a floating piston to separate oil from the gas. The vehicle specific multi-stage valving is set to balance ride and handling.
Key features
- Front monotube design for 3.5 inches of lift
- Extended length 24.6 inches, collapsed length 16.2 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Lift, caster and steering
Raising a Super Duty front end changes caster, ride height and the angle the shock works through, so the new damper should be matched to the lift it is installed with. Measure the height before and after installation, and note the change so the alignment can be set to match. The shock body needs room at full steering lock, and the front spring should sit correctly before the shock is fully tightened.
Loaded trucks put extra stress on front dampers, particularly when towing or carrying heavy equipment. Check the boot after the first few drives, and look for oil on the shaft or body. A shock that feels hard at one point in its travel can point to a bent or dirty shaft, which is worth inspecting before the truck goes off road again.
- Recheck the alignment after lift changes
- Confirm the stem top seats fully
- Check steering clearance at full lock
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2129 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 24.6 in |
| Collapsed length | 16.2 in |
| Lift | 3.5 in |
| Shaft | 14 mm chrome hardened |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2017 to 2021 Ford F-250 Super Duty and F-350 Super Duty, in several trims including King Ranch, Lariat, Limited, Platinum, XL and XLT.
Built for 2017 to 2021 Super Duty trucks; confirm fit for your year, model and trim before ordering.
Installation notes
The 3.5 inch lift this shock is designed for should match the Super Duty before ordering. Compare the 24.6 inch extended and 16.2 inch collapsed lengths with the original front shock. The stem top and loop bottom mounts need to line up with the factory brackets, and the boot should be checked for a clean seal before the truck is taken off road.
A 3.5 inch lift on a Super Duty changes the front ride height and the caster, so check the alignment and the clearance of the shock body at full steering lock after installation. Confirm the stem top seats and the lower mount is tight.
Once the front is set, confirm the shock body clears the steering linkage, the brake hose and the front spring at full lock.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2129.









