Overview
The Pro Comp Suspension ES3000 325510 is a front hydraulic shock absorber for the 1978–1979 Ford Bronco in the Custom, Northland and Ranger XLT versions. It uses the factory upper and lower mounts, and its lengths are set to the vehicle rather than one fixed size.
Pro Comp rates the shock for a 2 to 4 in. lift. It is sold as each. Pro Comp’s twin tube cellular gas construction includes 10-stage velocity-sensitive valving, a 5/8 inch chrome-hardened piston rod and a Teflon rebound stop. Double welded mounts add strength, and the shock carries the Pro Comp Suspension limited lifetime warranty.
Key features
- Twin tube cellular gas design
- 10-stage velocity-sensitive valving
- 5/8 inch chrome-hardened piston rod
- Teflon rebound stop
- Double welded shock mounts
- Factory upper and lower mounts
- Rated for a 2 to 4 in. lift
- Pro Comp Suspension limited lifetime warranty
Bronco lift and front shock load
Early Broncos carried a lot of weight at the front, and a lift changes the angle of the front shocks. A shock that works well at factory height can feel harsh or fail to control the springs once the suspension has been raised. Measuring the old unit and the ride height before ordering helps the new shock match the setup.
On a Bronco, the front shocks also control steering wander and body lean on rough roads. Worn bushings at the upper and lower ends can allow the shock to rotate and bind. When fitting a new front shock, check the springs, control arm bushings and steering linkage. A pair of fronts usually performs more consistently than a single replacement.
- Measure ride height before and after the job
- Check upper and lower bushings for play
- Inspect steering linkage for wear
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 325510 |
| UPC | 614901042252 |
| Shock series | ES3000 |
| Position | Front |
| Type | Hydraulic, twin tube cellular gas design |
| Extended, collapsed and travel lengths | Vehicle specific |
| Upper mount | Factory |
| Lower mount | Factory |
| Lift height rating | 2 to 4 in. lift |
| Adjustable | No |
| Remote reservoir | No |
| Finish | White |
| Boot included | No |
| Sold as | Each |
Vehicle fitment
It fits the 1978–1979 Ford Bronco Custom, Northland and Ranger XLT versions. Ford Broncos from 1977 and earlier and from 1980 onward are not covered. Confirm your vehicle’s year, model and trim before ordering.
Ford Broncos from 1977 and earlier and from 1980 onward are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 2 to 4 in. lift rating covers a range rather than one height, so measure your Bronco’s suspension before fitting. Check the vehicle-specific lengths against the shock being replaced.
What’s included
One shock absorber, part 325510.
Not included: the dust boot.










