Overview
The Pro Comp CV-Style Front Drive Shaft, part number 55837B, is a front drive shaft with u-joint style joints for 2007-2008 Jeep Wrangler JK 4WD vehicles with 2 inches or more of lift. It fits 2-door and 4-door models of those years.
On a lifted vehicle the driveline angles increase, which raises the chance of driveline vibration. The u-joint style shaft allows 4WD operation at speeds above 25 mph and replaces the factory ball-and-cage joint for more range of motion. It is suited to 2 inches or more of lift and uses 1314 style u-joints.
Key features
- Front drive shaft for 2007-2008 Jeep JK 4WD vehicles
- Suited to vehicles with 2 inches or more of lift
- 2-door and 4-door models
- Replaces the factory ball-and-cage joint with u-joints
- Yokes rather than flange adapters, allowing a longer shaft
- 2.00 in. x 0.120 in. DOM steel tube
- Does not require a slip yoke eliminator
- Mounting hardware included
Front shaft and lift angles
The front drive shaft carries power from the transfer case to the front axle, and both ends must work through the full suspension travel. Joint angles grow with lift, so the yokes, tube and joint style all affect how smoothly the shaft runs. A u-joint design gives more articulation than a fixed joint, which helps on uneven trails.
Front shafts wear with time and rough use. Pay attention to vibration that changes with speed, clicking through a turn, or grease leaking from the caps. Before buying, confirm the axle housing, transfer case and steering clearance, because a shaft may still rub nearby parts if the lift is large.
- Measure front axle and transfer case angles
- Check steering stops and tie rod clearance
- Inspect u-joint caps for leaks
- Tighten hardware after the first few drives
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 55837B |
| UPC | 614901126792 |
| Product type | Front drive shaft, CV style |
| Position | Front |
| Length | Extended |
| Joint style | U-joint (1314 style listed; #1310 style also mentioned) |
| Tube | 2.00 in. x 0.120 in. DOM steel |
| Lift range | 2 inches or more (description); 0-6 inch (short text) |
| Body styles | 2 and 4-door models |
| Slip yoke eliminator required | No |
| Fit type listed | Universal fit |
Vehicle fitment
The shaft fits 2007-2008 Jeep Wrangler JK 4WD vehicles in 2-door and 4-door models.
Years after 2008 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Driveline and axle parts rotate at speed, so professional installation is the safer choice. Put the vehicle on jack stands before dropping the old driveshaft, and tighten the u-joint and flange hardware to the torque values for the fasteners. Check clearance and joint angles through the full range of suspension travel, and re-check fasteners and fluid levels after the first few miles of driving. After any suspension or driveline change, listen for vibration and have it inspected if it appears.
What’s included
Mounting hardware is included with the kit.












