Overview
The Pro Comp PXA5162-218947 is a 20×10 aluminum split-spoke wheel from the Pro Comp 62 Series Apex line, in satin black milled with an 8 on 180 bolt pattern. It is sold as one wheel with a center bore of 125.
Pro Comp built the Apex with low-pressure casting, and its alloy range is rated from 2500 to 3650 lbs per wheel. This wheel is 10 inches wide with an offset of -18 and a backspacing of 4.75. Measure the hub before ordering, since the eight-lug pattern must match exactly.
Key features
- Low-pressure cast aluminum
- Split-spoke design
- 20-inch diameter and 10-inch width
- 8 on 180 bolt pattern
- Center bore of 125
- Offset -18 with 4.75 backspacing
Choosing the right setup
A split-spoke wheel of this size changes how the tire sits relative to the fender and suspension, so the offset and backspacing deserve as much attention as the bolt pattern. A negative offset such as -18 pushes the tire outward, which can improve stance but reduces room for brake calipers and steering parts. Shoppers with a lifted setup or a wider tire should measure inner clearance with the tire mounted and the suspension at full travel.
Lug nut seat style should match the wheel, and the hub face should be clean and flat before the wheel goes on. Re-torque the nuts after the first few drives, since new wheels can settle slightly against the hub. Recheck clearance any time the tire size or ride height changes, because small changes can bring the tire into contact with inner parts.
- Measure the hub pattern before buying
- Check clearance with the tire mounted
- Re-torque lug nuts after the first drives
Specifications
| Brand | Pro Comp Alloy Wheels |
|---|---|
| Part number | PXA5162-218947 |
| Series | 62 Series Apex |
| Style | Split spoke |
| Construction | Aluminum |
| Finish | Satin black milled |
| Diameter | 20 inches |
| Width | 10 inches |
| Bolt pattern | 8 on 180 |
| Center bore | 125 |
| Offset | -18 |
| Backspacing | 4.75 |
| Load rating | 2500 to 3650 lbs per wheel (Pro Comp alloy range) |
Vehicle fitment
Fit is set by the hub rather than a named model. The 8 on 180 hub and 125 center bore are the first checks, followed by clearance at the -18 offset.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Eight lug holes at 180 must line up with the hub, so a 170 or 6.5 hub will not take this wheel. Confirm the pattern on the vehicle, then test-fit the 10-inch rim with the tire. The 180 hub pattern is specific, so double-check the vehicle’s hub before buying. Because the 8 on 180 spacing is uncommon, confirm the bolt circle on the vehicle with a measurement rather than assuming it.
What’s included
One 20×10 aluminum wheel in satin black milled.











