Overview
The Pro Comp EXPK4178T, also written K4178T, is a 6-inch Stage II lift kit for the 2011–2016 Ford F-250 Super Duty. It includes PRO-X shocks and replacement radius arms, and it is a direct fit for those trucks.
This is the same 2011–2016 F-250 Stage II system as the K4176T, with its own part number. The kit pairs a drop pitman arm and laser-cut brackets for steering and suspension geometry with coil springs, replacement radius arms and PRO-X shocks.
Key features
- Drop pitman arm, which Pro Comp uses to hold steering geometry
- Laser-cut brackets
- Coil springs that increase ride height.
- PRO-X front and rear shocks, included
- Direct fit to the listed 2011–2016 F-250 Super Duty
Before you install
Lift kits change more than ride height. Raising the front and rear moves the axle, the steering linkage and the driveline angles, so the kit should be treated as a full suspension job rather than a simple bolt-on. Start with a clean look at the old radius arms, brackets and bushings, since worn parts are often replaced alongside new ones to keep the geometry tight.
Once the truck is at its new height, plan for a four-wheel alignment and a check of the pitman arm angle. Re-torque fasteners after the first few drives, and watch for rubbing at the tires and brake lines through the turns. Shock length should also be checked at full extension so the new shocks are not bottomed out on the bump stops.
Keep a simple log of each service, including torque checks, alignment dates and any bushing replacements. It makes later troubleshooting far easier and shows when parts are due.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPK4178T (K4178T) |
| Kit type | Lift kit, complete suspension system |
| Kit stage | Stage 2 |
| Lift height | 6 inches, with a lift height range of 6–7 inches |
| Radius arms | Replacement, 4130 chromoly tubing with 3/16-inch steel plate |
| Rear lift method | Block and spacer |
| Rear lift component | Block and U-bolt with add-a-leafs |
| Front shocks | PRO-X |
| Rear shocks | PRO-X |
| Shocks included | Yes |
| Fitment type | Direct fit |
Vehicle fitment
The kit fits the 2011–2016 Ford F-250 Super Duty in the King Ranch, Lariat, Platinum, XL and XLT trims.
Trucks from 2017 onward and the F-350 Super Duty are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing the radius arms changes how the axle is located, so the alignment and the pitman arm setup need to be checked after the install.
What’s included
The kit includes replacement radius arms, coil springs, a drop pitman arm, a block and U-bolt rear set and PRO-X shocks. Check the package contents against your installation before starting.














