Select your vehicle

Pro Comp 5.5 Inch Rear Lift Block – 95-557SD

Pro Comp Suspension

Shop on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • 5.5-inch and up rear lift block for leaf spring trucks
  • Sold as a single block
  • Universal fit, no vehicle listed
  • Part number 95-557SD

Description

Overview

The Pro Comp 95-557SD is a single rear lift block at 5.5 inches and up for leaf spring trucks. Each block is sold individually and is for the rear only, so a riser block should never be fitted at the front of any vehicle.

Each part number is one block, so count how many your rear suspension needs before buying. Confirm the vehicles this block suits, its thickness and the bolts needed for fitting.

At the 5.5-inch and up height, the driveshaft angle and the U-bolt length change the most. Confirm the lift against your current suspension before choosing this block.

Key features

  • Rear lift of 5.5 inches and up
  • Sold as a single block
  • For rear use only

Single block planning

Buying one block at a time suits trucks where only one side needs lifting or where a second block is already on hand. Most rear suspensions use a matched pair, so measure both sides before ordering and make sure the spring arch is level after fitting. Uneven blocks can pull the axle out of square and affect braking and steering stability.

Before installing, clean the spring pad and check the spring seat for cracks or rust, since a lift block loads that area more heavily. Replace worn shackle bushings and U-bolts at the same time when they are already off the truck, which saves a second job later and keeps the rear axle aligned.

  • Compare both rear springs before ordering
  • Inspect spring seats for cracks
  • Replace worn shackle bushings during install

Specifications

Brand Pro Comp Suspension
Part number 95-557SD
Position Rear
Lift 5.5 in and up
Quantity Single block

Vehicle fitment

Confirm fit for your vehicle’s year, model and rear suspension before ordering.

A rear lift block is sized for a specific leaf spring setup, so do not assume fit from the part name. Confirm your vehicle’s year, model and trim before ordering.

Installation notes

Install the block at the rear only. Check the driveshaft angles and the U-bolt length after installation, and confirm there is room for the brake lines at the new height.

What’s included

One rear lift block.

Not included: the second block, if your truck needs one, and U-bolts.

Questions & Answers

Is the 95-557SD sold as one block?

Yes. Each block is sold individually, so each part number is one block rather than a pair. Check how many your rear suspension needs before ordering.

Can the 95-557SD go on the front?

No. The block is for the rear only, and a riser block should never be used on the front of any vehicle. Keep it at the rear axle and do not fit it at the front.

What lift does the 95-557SD give?

The lift is 5.5 inches and up. Check the driveshaft angles and U-bolt length after installation to confirm the height suits your truck and driveline.

Do lift blocks wear the spring pad over time?

They can. A block adds load to the spring seat and pad, so look for cracks, flattening or rust at each service. Keep the U-bolts tight and check the block for movement after the first trail runs.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop on Amazon