Overview
The Power Stop K5490-36 is a rear Heavy Duty Truck and Tow brake kit for the 2003–2008 Dodge Ram 2500 and 3500.
It brings slotted, cross-drilled rotors and Z36 Truck and Tow pads to the rear axle of the third-generation heavy-duty Ram. The existing calipers stay. Rotors and pads that are designed as a pair take the guesswork out of a brake refresh. Power Stop describes its kits as a quick, direct route to better braking, and says they produce more pad bite than other leading brands without added noise or dust.
Key features
- Matched rotor and pad set from Power Stop’s Truck and Tow line
- Slots and cross-drilled holes in each rotor
- High-friction metallic Z36 pads
- Built for tow vehicles and loaded trucks
- Direct-fit design
- Kit does not include brake lines or calipers
Towing and heavy-duty braking
A truck that tows heavy loads asks more of its brakes on long descents, when the pedal is applied for extended periods. Heat builds in the rotors and pads, and pad material can fade if the brakes run hot for too long. Heavy-duty pads are designed to hold friction under those conditions.
Good towing braking also depends on the rest of the system. A trailer brake controller, correctly adjusted, shares the load with the truck’s brakes. Check the brake hoses and fluid as part of a service, and avoid riding the pedal down long grades. Maintenance helps the new rotors and pads perform the way they were designed.
- Use engine braking on long downhill runs
- Check trailer brake controller settings
- Inspect brake fluid condition at service
Specifications
| Brand | Power Stop |
|---|---|
| Part number | K5490-36 |
| UPC | 792088949660 |
| Brake position | Rear |
| Rotor type | Slotted and cross-drilled |
| Brake pads | Z36 Truck and Tow high-friction metallic |
| Rotor coating | Coated |
| Calipers | Not included |
| Brake lines | Not included |
| Fit type | Direct fit |
Vehicle fitment
The kit fits 2003–2008 Dodge Ram 2500 and 3500 models. Ram trucks from 2009 on are not covered by this part number.
Ram trucks from 2009 on are not covered by this part number, and the kit is for the rear axle only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
No drilling or fabrication is needed for this direct-fit kit. The existing calipers are reused with the new rotors and pads. Replace pads and rotors as a pair on each axle.
What’s included
Matched rotors and Z36 high-friction metallic pads.
Not included: calipers and brake lines.









