Overview
The Power Stop Evolution AR8387XPR (part number PSTAR8387XPR) is a pair of drilled and slotted brake rotors for the 2018–2026 Jeep Wrangler JL, including Unlimited, Rubicon, Sahara, Sport and Willys versions.
The cross-drilled holes are designed to run rotors up to 180F cooler. The rotors have a direct OE fit and vane count, so no special modifications are needed on your car, truck or SUV.
The Wrangler JL is the 2018 and later generation of the Jeep Wrangler. This rotor covers the 2-door and 4-door Unlimited bodies. Tru-Cast machining and G3000 grade iron are part of the build.
The rotor is machined to a run-out within 0.0015 and a DTV tolerance within 0.005. Every Evolution rotor is mill balanced.
Key features
- Cross-drilled holes keep rotors up to 180F cooler.
- Precision machined using Tru-Cast technology
- Rotor run-out within 0.0015 and DTV tolerance within 0.005
- Mill-balanced; G3000 grade cast
- Silver zinc plated to shield against rust
- Direct OE fit and vane count, supplied as a pair
Before you replace rotors
Rotor wear is usually easiest to spot by feel and sound. Pulsation through the pedal or steering wheel under braking often points to uneven thickness or runout, while a grinding or scraping noise can mean the pads have worn down to the backing plate. Drilled and slotted rotors can show fine cracks near the holes over time, which is normal for this design, but deep or spreading cracks mean the disc should be replaced.
Replace rotors in pairs on the same axle so braking stays even from side to side. Bed in new pads after installation, and torque the wheel bolts to the vehicle’s specification. Because the Wrangler JL is used on pavement and on trails, mud and water can speed up surface rust on exposed discs, so a quick inspection after off-road trips is worthwhile.
- Clean hub surfaces before mounting to prevent runout
- Recheck bolt tightness after the first few drives
- Inspect rotor edges for a lip that signals heavy wear
Specifications
| Brand | Power Stop |
|---|---|
| Part number | PSTAR8387XPR |
| Product type | Brake rotors, drilled and slotted |
| Disc material | Cast iron (G3000 grade) |
| Coating | Silver zinc plated |
| Run-out | Within 0.0015 |
| DTV tolerance | Within 0.005 |
| Quantity | Pair |
| Fit | Direct fit |
Vehicle fitment
It fits the 2018–2026 Jeep Wrangler (JL) in 2-door and 4-door Unlimited versions, including Sport, Sport S, Willys, Rubicon, Rubicon 392, Sahara, Moab, High Altitude, Freedom, Islander and 80th Anniversary trims, plus the 4xe plug-in hybrid versions. One part number covers all of these.
The JK, TJ and YJ Wranglers are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Because the rotors follow the original vane count, they bolt in where the factory rotors were; fit both sides with new pads, and check the Wrangler’s rotor diameter and lug pattern against the part before installing it.
What’s included
One pair of rotors.
Not included: Brake pads and mounting hardware.










