Overview
The Power Stop AR8587XPR is a rear slotted and cross-drilled brake rotor for the 2002–2010 Ford Explorer and Mercury Mountaineer and the 2007–2010 Ford Explorer Sport Trac. The AR8587XPR is made for the rear axle, uses cross-drilled holes together with slots, and arrives coated.
A G3000 grade casting and silver zinc plating give this rotor its rust protection, and the drilled and slotted face looks good behind factory or custom wheels.
For 2002-2010 Explorer, Mountaineer, 2007-2010 Sport Trac, the AR8587XPR replaces the original rear rotor with a drilled and slotted version that Power Stop says keeps a clear contact patch between pad and rotor.
Key features
- Rounded slots clear water, gas and dust
- Cross-drilled holes for cooling
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Rear rotor replacement basics
Rear rotors on Explorer and Mountaineer models share the load with the parking brake on many trims, so the hub and rotor hat need careful cleaning before the new rotor goes on. Rust that builds up on the mating surface can throw the rotor slightly out of true, which shows up as pedal pulsing. A drilled and slotted face is easier to clean of rust between the holes, but the hub still has to be bare metal where the rotor sits.
Rear pads on these vehicles wear unevenly when the slides are stiff, so check the caliper pins and boots during service. Replace the pads when the friction material is thin, and consider new hardware clips at the same time. Keep the rotor face free of oil and brake fluid, and avoid touching the friction surface with bare hands.
- Clean rust from the hub face
- Check caliper slide pins for free movement
- Replace worn pad hardware clips
- Bed in new pads after installation
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8587XPR |
| UPC | 792088553188 |
| Type | Slotted and cross drilled |
| Position | Rear |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | The drilled holes keep rotors up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
It fits these vehicles: 2002–2010 Ford Explorer (Eddie Bauer, Limited, XLS, XLS Sport, XLT, XLT Sport); 2007–2010 Ford Explorer Sport Trac (Limited, XLT); and 2002–2010 Mercury Mountaineer (Base, Convenience, Luxury, Premier). It covers 3 vehicle entries with model years from 2002 to 2010.
The 2001–2005 Sport Trac is not on the AR8587XPR list, and Explorer generations before 2002 or after 2010 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install the AR8587XPR on the rear axle only, and plan on fresh brake pads, since a drilled and slotted face works with pads that are in good condition.









