Overview
The Power Stop AR85155XPR is a rear drilled and slotted brake rotor for the 2013–2017 Ford F-250 Super Duty and F-350 Super Duty. The AR85155XPR is made for the rear axle, uses cross-drilled holes together with slots, and arrives coated.
The holes are beveled and precision drilled to help hold temperatures down during extreme braking, and the rounded slots keep the pad-to-rotor contact patch clear of water, gas and dust.
Shoppers comparing rear rotors for 2013–2017 Ford F-250 and F-350 Super Duty will find the AR85155XPR described by Power Stop as precision machined with Tru-Cast technology, with holes and slots that reduce fade.
Its cross-drilled and slotted face suits street and day track use, pairing drilled-hole cooling with slots that clear gas and dust.
Key features
- Rounded slots clear water, gas and dust
- Cross-drilled holes for cooling
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Rear rotor care
Rear rotors on a Super Duty carry less load than the fronts, but they still handle heat from towing, hills and frequent stops. A drilled and slotted face helps clear water, gas and dust from the pad contact area, which keeps braking more consistent in wet or dirty conditions. The cooling holes are most useful when the rear brakes work hard.
During a pad change, check the rotor face for cracks, deep scoring and heat spots. Measure thickness against the minimum marked on the rotor, and look for a raised lip on the outer edge that can cause pad knock. Clean the hub mounting face and remove any rust before fitting the new rotor.
Rear pads often wear more slowly than front pads, but a rear rotor that is worn or warped will still cause vibration and noise. Fit fresh pads with the rotor and bed them in before normal use. Replacing both sides of the rear axle together keeps braking even.
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR85155XPR |
| UPC | 792088819192 |
| Type | Slotted and cross drilled |
| Position | Rear |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | The drilled holes help keep rotors up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
The AR85155XPR fits 2013–2017 Ford F-250 Super Duty (King Ranch, Lariat, Platinum, XL, XLT) and 2013–2017 Ford F-350 Super Duty (King Ranch, Lariat, Platinum, XL, XLT).
It is a rear rotor for the rear axle only. Coverage is limited to the 2013–2017 model years, so match your year, model and trim before ordering.
Installation notes
The AR85155XPR is a direct-fit replacement, so it goes on the rear hubs of the listed vehicles in place of the original rotors; replace both sides of the axle together.












