Select your vehicle

Power Stop Evolution Drilled and Slotted Brake Rotors – JBR949XPR

Power Stop

Shop Hyundai Santa Fe Disc Brake Rotors on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Front rotors for the 2001–2005 Hyundai Santa Fe
  • Vented cast iron, slotted and cross drilled, 5 lugs
  • Zinc dichromate plated and mill-balanced
  • Power Stop part number PSTJBR949XPR

Description

Overview

The Power Stop Evolution JBR949XPR (part number PSTJBR949XPR) is a pair of front drilled and slotted brake rotors for the 2001–2005 Hyundai Santa Fe.

The vented cast iron rotors have 5 lugs. Power Stop says each rotor is machined and mill-balanced and plated with silver zinc dichromate to help prevent rust and corrosion.

This rotor covers the 2001–2005 Santa Fe. Power Stop applies the same drilled and slotted treatment it uses across the Evolution line, with zinc dichromate plating on the disc to help it resist rust.

Run-out is the side-to-side wobble of a spinning rotor, while DTV is the difference in thickness across the disc. Power Stop publishes both limits so the rotor’s tolerances can be checked.

Key features

  • Precision drilled holes allow rotor cooling in demanding conditions
  • Rounded slots wipe away gas and debris
  • Silver zinc dichromate plating, except on hub assemblies
  • Each rotor machined and mill-balanced
  • Maximum run-out 0.0032 in (0.08 mm); maximum DTV tolerance 0.0005 in (0.0125 mm)
  • Vented cast iron, 5 lugs, direct OE fit

Before you install

Start by confirming the vehicle is on a level surface and the wheel is removed safely. Clean the hub face with a wire brush so no rust or old rotor rust rings remain, because even a thin layer of corrosion can make the new rotor sit slightly off-true. A short test fit before the pads and caliper go on is a useful step on an older vehicle.

Older Santa Fe models often have hubs and brake hardware that have seen years of road salt. Replace worn caliper slide pins and boots while the rotors are off, since the pads will otherwise drag or wear unevenly. A plated rotor resists surface rust, but it is still good practice to wipe the friction face clean before the first stops.

  • Wire brush the hub mating surface
  • Inspect or replace caliper guide pins
  • Clean the friction face before the first drive

Specifications

Brand Power Stop
Part number PSTJBR949XPR
Product type Front brake rotors, drilled and slotted
Disc material Cast iron
Disc design Vented
Position Front
Number of lugs 5
Coating Coated (silver zinc dichromate)
Maximum run-out 0.0032 in (0.08 mm)
Maximum DTV tolerance 0.0005 in (0.0125 mm)
Quantity 2-wheel set
Fit Direct fit

Vehicle fitment

It fits the 2001–2005 Hyundai Santa Fe in Base, GL, GLS and LX versions, across all model years from 2001 through 2005.

The 2006 and later Santa Fe is a different generation and is not part of this fit range. The rotor is made for the front axle only. Confirm fit for your vehicle’s year, model and trim before ordering.

Installation notes

Replace both front rotors together and fit new pads, so each side has a matching fresh friction surface. Check that the lug count on the hub is 5 before installing.

What’s included

A pair of front rotors, one per wheel.

Not included: Brake pads, mounting hardware and the rear rotors.

Fitment

VehicleYearsTrims
Hyundai Santa Fe2001–2005Base, GL, GLS, LX

Use “Select your vehicle” at the top of the page to check this part against your vehicle.

Questions & Answers

Will the JBR949XPR fit a 2004 Hyundai Santa Fe?

Yes. It fits the 2004 Hyundai Santa Fe, which falls within the 2001–2005 range. It is a front rotor and does not replace the rear brakes, which use separate parts.

What does the plating on the JBR949XPR do?

The silver zinc dichromate plating is there to help prevent rust and corrosion. Power Stop applies it to its drilled and slotted rotors except hub assemblies, so the disc keeps a cleaner look behind the wheel.

Is the JBR949XPR vented?

Yes. It is a vented cast iron rotor with 5 lugs, supplied as a set of two for one front axle of a listed Santa Fe.

What does zinc dichromate plating add to the rotor?

The plating helps resist surface rust in damp or salted conditions. It does not change how the rotor brakes, so keep the friction face clean and inspect it at regular intervals.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop Hyundai Santa Fe Disc Brake Rotors on Amazon