Overview
The Power Stop AR8743XPR is a rear slotted and cross-drilled brake rotor for the 1999–2004 Jeep Grand Cherokee (WJ). The rotor uses a G3000 grade cast, and Power Stop’s drilled and slotted rotors carry a silver zinc plating that helps shield them from rust during normal operation.
It suits owners of the 1999–2004 Jeep Grand Cherokee (WJ) who want a rear rotor with a slotted and cross drilled face rather than a plain disc. Choose by axle position first, then confirm the model.
Owners look at drilled and slotted rotors when they want a surface that clears water and dust more readily than a plain disc.
Key features
- Slotted and cross-drilled rear rotor
- Direct fit for the listed vehicles
- Coated rotor
- Rounded slots that sweep water, gas and dust from the pad contact patch
- Silver zinc plated to shield against rust during normal operation
- Cross-drilled holes that Power Stop says keep rotors up to 180°F cooler
- Mill balanced
- Looks good behind custom or factory wheels
- Tru-Cast precision machining
Bedding and torque tips
Bedding new pads and rotors transfers an even layer of friction material to the rotor face, which helps quiet braking and steady pedal feel. Make a series of moderate stops from modest speed, then let the brakes cool before any hard stop. Good bedding also helps the pads grip evenly from the first stop.
Tighten the fasteners to the torque value for your vehicle, since overtightening can distort the rotor and loose bolts can cause vibration. Rear hardware on this generation should be checked again after the first few trips.
Check the rotor surface for even contact after the first few trips, and recheck the lug nuts after a short drive. Keep the brake fluid at the proper level and inspect hoses during routine service.
- Set lug nut torque in a star pattern
- Recheck lug nuts after a short drive
- Make gradual stops during bedding
- Check fluid level during service
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8743XPR |
| UPC | 792088554093 |
| Product type | Slotted and cross-drilled disc brake rotor |
| Position | Rear |
| Fit type | Direct fit |
| Coating | Rotors coated |
| Casting | G3000 grade cast |
| Plating | Silver zinc |
| Machining | Tru-Cast precision machined |
| Rotor run-out | Within 0.0015 |
| DTV tolerance | Within 0.005 |
| Balance | Mill balanced |
Vehicle fitment
This rotor fits the 1999–2004 Grand Cherokee (WJ) in its Laredo, Limited, Overland, Special Edition and Sport trims.
Confirm the rotor diameter, thickness, bolt pattern and weight against the existing part before swapping.
Only the WJ generation (1999–2004) is listed; the earlier Grand Cherokee (ZJ) is not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use the fastener torque figures in the vehicle’s service manual when mounting the rotor and caliper.
What’s included
The rotor ships alone, with no extra components included.
Not included: Pads, hardware and any brake fluid are separate items and are not part of the rotor listing.









