Overview
The Power Stop JBR1121XPR is a front slotted and cross-drilled brake rotor for the 2003–2009 Toyota 4Runner, 2007–2014 Toyota FJ Cruiser and 2005–2015 and 2017 Toyota Tacoma. Evolution rotors from Power Stop are mill balanced, and their drilled and slotted faces are finished with silver zinc plating.
It is designed for owners of the 2003–2009 Toyota 4Runner, 2007–2014 Toyota FJ Cruiser and 2005–2015 and 2017 Toyota Tacoma who want a front rotor with a drilled and slotted face.
A brake rotor is the disc that the brake pads clamp against to slow the wheel. Drilled and slotted versions change the face of that disc to move heat and debris away from the pad.
Key features
- Slotted and cross-drilled front rotor
- Direct fit for the listed vehicles
- Coated rotor
- Rounded slots that sweep water, gas and dust from the pad contact patch
- Silver zinc plated to shield against rust during normal operation
- Cross-drilled holes that Power Stop says keep rotors up to 180°F cooler
- Mill balanced
- Looks good behind custom or factory wheels
- Tru-Cast precision machining
Rotor face and debris
The face of a drilled and slotted rotor is designed to clear dust, water and gas from the pad surface. Clean, consistent contact helps the pad grip evenly, which is why the rotor face matters as much as its size. Silver zinc plating protects the cast iron from surface rust while the vehicle is parked, though light surface rust is normal and usually cleans off in the first stops.
Owners of 4Runners, FJ Cruisers and Tacomas often use their trucks off-road, where mud and grit can pack into the slots. Rinse the rotor after deep water or mud crossings and check the pads for embedded grit. Rotors that are cracked near the holes or worn below minimum thickness should be replaced rather than kept in service.
- Rinse mud and grit after off-road use
- Check pads for embedded debris
- Clean rust from the hub face before mounting
- Replace rotors that show cracks near the holes
Specifications
| Brand | Power Stop |
|---|---|
| Part number | JBR1121XPR |
| UPC | 792088557810 |
| Product type | Slotted and cross-drilled disc brake rotor |
| Position | Front |
| Fit type | Direct fit |
| Coating | Rotors coated |
| Casting | G3000 grade cast |
| Plating | Silver zinc |
| Machining | Tru-Cast precision machined |
| Rotor run-out | Within 0.0015 |
| DTV tolerance | Within 0.005 |
| Balance | Mill balanced |
Vehicle fitment
It fits these vehicles and trims: 2003–2009 Toyota 4Runner (Limited, SR5, Sport); 2007–2014 Toyota FJ Cruiser (Base, TRD Special Edition, Trail Teams Special Edition); 2005–2015, 2017 Toyota Tacoma (Base, Limited, Pre Runner, SR, SR5, TRD Off-Road, TRD Pro, TRD Sport).
Confirm the rotor diameter, thickness, bolt pattern and weight against the rotor you are replacing before fitting.
The 4Runner is covered for 2003–2009 and the FJ Cruiser for 2007–2014. The Tacoma is covered for 2005–2015 and 2017, so the 2016 model year is outside the fit. The 2010 and later 4Runner is not covered.
Installation notes
Compare the old rotor against the new one before mounting to confirm the hub opening and vane design match.
What’s included
This is a single front rotor sold on its own.
Not included: No brake pads or caliper hardware are listed with the rotor, so they would come separately.









