Overview
The Poison Spyder Ricochet Rockers, bare steel, part number 13-50-050, are formed rocker armor with a 5 inch dimpled step and slider, written for use with TJ fender flares. The product is built with 1.5 inch DOM tubing for the slider and 3/16 inch steel for the step and corner gussets, and it is sold ready to paint and bolt on. The step plate is 5 inches across and is reinforced by the bracing below it. The kit uses countersunk 3/8 inch stainless hardware, so the fasteners sit flush.
The step adds a foothold for getting into the vehicle, and its dimples point upward for extra grip in snow or mud. The Ricochet Rocker can be used alone or with Crusher Corners, and the two pieces meet at the rear flare to guard the body from the front wheel well to the tailgate.
Key features
- 5 inch dimpled plate that works as a step and reinforcement
- Dual tube support and slider bar of 1.5 inch DOM tubing
- Step and corner gussets of CNC laser-cut 3/16 inch steel
- Further reinforced with bracing below the dimpled step
- Professionally welded and ready to paint
- Works alone or with Crusher Corners
Before you mount it
A rocker guard takes the first hit from rocks, stumps and ledges, so its mounting is as important as its steel. Bolting a plate to the rocker panel puts load on the body seams and the frame rail area, so the mounting points should be solid and free of rust before you drill anything.
Mark and check every hole before cutting. Because the bare steel arrives ready to paint, plan to prime and paint the guard before final install, and apply paint to any cut or drilled edges to slow corrosion.
- Check the body mount points for rust or cracks
- Mark all holes and confirm alignment before drilling
- Prime and paint after fitting if you want a matching finish
- Inspect the bolts after the first few trail runs
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 13-50-050 |
| UPC | 614901724639 |
| Type | Formed plate guard with tubular standoff |
| Finish | Bare steel, ready to paint |
| Step | 5 inch dimpled plate |
| Slider tube | 1.5 inch DOM, dual tube support |
| Gussets | 3/16 inch steel, CNC laser-cut |
| Fasteners | Countersunk 3/8 inch stainless |
| Installation | Cutting or drilling required |
Vehicle fitment
These rockers are written for TJ fender flares, which means they fit the Jeep Wrangler TJ, 1997 to 2006. Confirm your Jeep has TJ flares and check the mounting points against your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering. Rubber liners are sold separately.
Installation notes
Cutting or drilling is required, and the countersunk 3/8 inch stainless hardware is supplied with detailed instructions. If you want to protect the paint underneath, a precision cut rubber liner is sold separately.
What’s included
One Ricochet Rocker with dimpled step, DOM slider, countersunk hardware and instructions. A rubber liner is not part of the kit.









