Overview
The Poison Spyder DIY Short Ricochet Rockers, bare steel, part number DIY-50-040, is a do-it-yourself kit that adds a heavy duty rub rail and entry step to rocker armor, written for the JK 2-door, LJ and CJ-8. The kit is designed specifically for those models, and it may fit other vehicles, but that is not confirmed. Welding is required to install it.
The kit is named for the Ricochet Rocker because its components are similar to Poison Spyder’s Ricochet Rockers. It can be added to the stock Jeep JK Rubicon rocker rails, Rocker Knockers or other plate steel rocker armor, which makes it a rub rail and step upgrade rather than a full guard.
Key features
- DOM tube rub rails, CNC bent and pre-notched
- Rico Steps and end gussets laser cut from 3/16 inch plate steel
- Steps are brake-formed for extra strength
- Reverse-dimpled steps for foot traction
- Main tubes measure 54.5 inches long
- Ready to weld on
Before you weld
Welding is the main job with this type of rub rail kit, so the setup work matters more than the bolts. Clamp the tubes and steps in position on the vehicle, check that the rub rail sits level with the rocker and clears the tires at full steering lock, and mark the weld points before any heat goes on the steel. Bare steel rusts at the joints if left unprimed, so clean and prime the welds soon after the work is done.
Rub rails and steps take most of their load at the ends, where they meet the rocker and the gussets. Good penetration at those joints keeps the kit from peeling away after hard trail impacts. Re-check the welds and mounting points after the first few trail runs.
- Test fit every piece before the first weld
- Prime and paint bare steel welds promptly
- Inspect end gussets for cracks after hard use
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | DIY-50-040 |
| Type | Tubular guard with tubular standoff, DIY kit |
| Finish | Bare steel |
| Main tube length | 54.5 inch |
| Steps and gussets | 3/16 inch plate steel |
| Components | DOM tube rub rails, Rico Steps, end gussets |
| Installation | Welding required |
Vehicle fitment
The kit is designed for the JK 2-door, the LJ and the CJ-8. The JK is the Wrangler (JK), 2007 to 2018, and the LJ is the Wrangler (LJ), 2004 to 2006. Confirm the CJ-8 fit for your vehicle’s year, model and trim before welding.
Confirm fit for your vehicle’s year, model and trim before ordering, since other vehicles are not covered here.
Installation notes
Welding is required, so this kit suits a builder who can weld steel to the rocker rails. Test the layout on the vehicle before any weld goes in, since the tubes are pre-notched and ready to weld on as supplied.
What’s included
DOM tube rub rails, Rico Steps and end gussets, all CNC bent and pre-notched for welding.














