Overview
The Poison Spyder Rocker Knockers with Sliders, bare steel, part number 11-08-020, are body-mounted rocker guards with a tubular slider, built for the Jeep CJ7 from 1976 to 1986. The armor is high strength 3/16 inch plate steel and the slider is high strength DOM structural tubing.
The slider keeps the body sides a few inches away from taller rocks and trees. It can also be the pivot point used to turn the Jeep around an obstacle while searching for traction, and it serves as a short step when getting in and out.
The DOM slider is welded to the guard with spacers, so there is no separate slider to fit. The bolt holes are countersunk for flat hardware.
Key features
- High strength 3/16 inch plate steel, CNC laser-cut
- High strength DOM structural tubing slider
- Slider welded to the rocker knocker with DOM tube spacers
- Slider also works as a pivot and entry step
- Countersunk bolt holes for flat, unobstructed surfaces
- Mounts to the body with no gap when a body lift is installed
Setup and alignment
A guard and slider pair is only as good as its alignment, since the slider needs to line up with the guard on every spacer. Set the guard in position, check the gap at the front and rear, then tighten the bolts gradually so the parts do not pull out of line. Mark the bolt holes before drilling, because a shifted hole can stress the welds.
The slider adds a second contact point to the side of the Jeep, so it works best when the body mounts are sound. Inspect the spacers, the welded joints and the body attachment points after rough trails. Keep the step area free of debris so boots keep their grip.
- Check alignment before final tightening
- Mark bolt holes before drilling
- Inspect spacers and welds after rough trails
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 11-08-020 |
| UPC | 614901723410 |
| Type | Formed plate guard with tubular standoff and slider |
| Finish | Bare steel |
| Material | High strength 3/16 inch plate steel |
| Slider | High strength DOM structural tubing |
| Fasteners | Countersunk stainless steel flat-head, included |
| Installation | Cutting or drilling required |
Vehicle fitment
They fit the 1976 to 1986 Jeep CJ7. Confirm your Jeep is a CJ7 and check the year before ordering, since the slider is shaped to that body.
Confirm your vehicle’s year, model and trim before ordering. Rubber rocker liners are sold separately.
Rubber rocker liners are sold separately and fit between the guard and the body. The slider and guard are supplied as one welded piece, so the slider is not bolted on separately.
Installation notes
Cutting or drilling is required to mount the guard. The hardware and instructions are included, and the slider and guard should be lined up before the bolts are fully tightened. Rubber liners are sold separately.
What’s included
CJ7 rocker knockers with DOM sliders attached, along with the stainless hardware and instructions.












