Overview
The Poison Spyder DIY Slider Tube Kit, bare steel, part number DIY-08-020, adds a rugged DOM tube slider to Poison Spyder Rocker Knockers or other aftermarket plate steel rocker armor. It fits the Jeep CJ7, the Wrangler LJ, the Wrangler TJ and the Wrangler YJ, and the kit has 44.25 inch main tubes. Welding is required.
The kit includes the slider tubes and the short tube supports that brace each slider against the rocker, to do both sides of the Jeep. The DOM slider tubes are CNC bent and pre-notched to mount at an angle, which matches the ready-built Rocker Knockers with Sliders.
Key features
- DOM slider tubes, CNC bent and pre-notched
- Main tubes measure 44.25 inches long
- Short tube supports bracing the middle of each slider
- Covers both sides of the Jeep
- Tubes mount at an angle for protection away from the body
Sliders and rocker protection
A slider is the tube that runs along the bottom of the body between the wheels, taking the first contact when a rock, stump or ledge pushes into the side of the Jeep. Its job is to let the armor slide over an obstacle instead of crushing the rocker, and the supports keep the middle of the tube from flexing under that load. Mounting angle matters because a tube set too flat can catch on obstacles, while one set too steep can leave the rocker exposed.
Before buying, consider how the slider will attach. Welding to plate steel armor takes time and a clean setup, so plan the work and the fixture before starting. Sliders also wear at the ends and at the support joints, so inspect those welds after rough trail days and repair any cracks before the next run.
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | DIY-08-020 |
| UPC | 614901732405 |
| Type | Tubular guard, DIY kit |
| Finish | Bare steel |
| Main tube length | 44.25 inch |
| Components | Slider tubes and short tube supports |
| Installation | Welding required |
Vehicle fitment
It fits the 1976 to 1986 Jeep CJ7, the 2004 to 2006 Jeep Wrangler LJ, the 1997 to 2006 Jeep Wrangler TJ and the 1987 to 1995 Jeep Wrangler YJ. Confirm your Jeep is one of these models and that its year is in range before welding.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required for the slider tubes and supports. Test-fit the tubes against the rocker before welding, and check the mounting angle at each end, since the tubes are pre-notched to a set angle.
What’s included
Slider tubes for both sides, the short tube supports, and the bare steel tubing ready to weld.









