Overview
The Poison Spyder Rocker Knockers with Sliders, bare steel, part number 13-08-020, are body-mounted rocker guards with a tubular slider, written for the Jeep YJ from 1987 to 1995. The armor is 3/16 inch plate steel, and the slider is high strength DOM structural tubing welded to the guard with additional DOM tube spacers.
The slider adds side protection on the trail. It keeps the body sides a few inches away from taller rocks and trees, and it can serve as a pivot point when working the vehicle around an obstacle to find traction. It also works as a short entry step. The slider is a fixed part of the guard, not a removable skid, so it stays in place on the trail. The bolt holes are countersunk, which keeps the hardware flat against the surface. Mounting hardware is included in the kit.
Key features
- High strength 3/16 inch plate steel, CNC laser-cut
- Tubular DOM slider welded to the rocker knocker
- Additional DOM tube spacers for the slider mount
- Slider doubles as a pivot point and entry step
- Bolt holes countersunk for flat, unobstructed surfaces
- Mounts to the body with no gap when a body lift is installed
Trail use and slider care
A rocker guard with a slider takes a lot of abuse on the trail, mostly from rocks, stumps and tree roots. Bare steel shows scratches and surface rust quickly, so inspect the guard after each run and treat any bare spots early. Wire brush loose rust, then apply a rust-inhibiting primer and paint once the metal is clean and dry, since untreated steel can start to pit where water collects.
The slider and the spacers are the parts most likely to take a direct hit, so check the welds and the mounting holes after hard use. A cracked weld or a loose mounting point can change how the guard sits against the body. Rubber liners protect the paint behind the guard, and they should be inspected for wear and replaced when they begin to tear or flatten.
- Treat rust spots soon after trail use
- Inspect welds on slider and spacers
- Replace worn liners before paint damage
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 13-08-020 |
| UPC | 614901724271 |
| Type | Formed plate guard with tubular standoff and slider |
| Finish | Bare steel |
| Material | High strength 3/16 inch plate steel |
| Slider | High strength DOM structural tubing |
| Fasteners | Countersunk stainless steel flat-head, included |
| Installation | Cutting or drilling required |
Vehicle fitment
These rocker knockers are written for the Jeep YJ, 1987 to 1995, in the Wrangler (YJ) range used here. Confirm your Jeep is a YJ before ordering, since the guard and slider angle are shaped to that body.
Confirm your vehicle’s year, model and trim before ordering. Rubber rocker liners are sold separately.
Installation notes
Cutting or drilling is required, and the mounting hardware and instructions are included. The slider and guard should be lined up before the bolts are tightened. Rubber liners are available separately to protect the paint underneath.
What’s included
The rocker knocker with its welded DOM slider, plus the stainless hardware and instructions for the install.












