Overview
The Poison Spyder Ricochet Rockers, bare steel, part number 11-50-010, are formed rocker armor with a 5 inch dimpled step and slider. They are built for the 1976 to 1986 Jeep CJ7, and the step plate is reinforced to give an entry foothold.
The Ricochet Rocker is built with the same toughness as the Rocker Knocker, plus the added step. The dimples point upward, which helps grip when boots are wet with mud or covered in snow. Used with Crusher Corners, the two pieces guard the body from the front wheel well to the tailgate. The step is reinforced below the dimpled plate with additional bracing, and the gussets are brake-formed so they act as their own support. Each Ricochet Rocker arrives welded, so it needs only to be bolted on.
Key features
- 5 inch dimpled step that reinforces the slider
- Dual tube support and slider bar of 1.5 inch DOM tubing
- Step and corner gussets of CNC laser-cut 3/16 inch steel
- Brake-formed gussets for strength and a clean appearance
- Professionally welded and ready to paint
- Works alone or with Crusher Corners
Keeping the step in shape
A dimpled step on a rocker takes repeated foot traffic, mud and water, so its finish and welds get tested often. Keep the step free of debris, and look for signs of stress where the step plate meets the tube. A reinforced step plate holds up better when the gussets and slider are in good shape.
If the Ricochet Rocker is used with Crusher Corners, the two pieces should be checked together for alignment at the rear flare. Gaps or bent edges at the joint show the armor has taken a hit and should be inspected before the next trail run. A rubber liner helps prevent rubbing along the body.
- Keep the dimpled step clear of mud
- Check gussets for cracks after trail use
- Inspect the rear-flare joint when using Crusher Corners
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 11-50-010 |
| UPC | 614901723687 |
| Type | Formed plate guard with tubular standoff |
| Finish | Bare steel, ready to paint |
| Step | 5 inch dimpled plate |
| Slider tube | 1.5 inch DOM, dual tube support |
| Gussets | 3/16 inch steel, CNC laser-cut |
| Fasteners | Countersunk 3/8 inch stainless |
| Installation | Cutting or drilling required |
Vehicle fitment
They fit the 1976 to 1986 Jeep CJ7. Confirm your Jeep is a CJ7 and that its year falls in that range before ordering, since the Ricochet Rocker is shaped to that body.
Confirm your vehicle’s year, model and trim before ordering. Rubber liners are sold separately.
Installation notes
The rockers need cutting or drilling, and they are fastened with countersunk 3/8 inch stainless hardware. Detailed installation instructions come with the kit. A precision cut rubber liner is available separately to protect the paint.
What’s included
CJ7 Ricochet Rocker with dimpled step, slider and countersunk stainless hardware, with instructions included.














