Overview
The Poison Spyder Rocker Knockers, bare steel, part number 11-08-010, are body-mounted rocker guards built for the Jeep CJ7 from 1976 to 1986. They are cut from high strength 3/16 inch plate steel and brake-formed to a precise fit, so they follow the rocker panel closely.
The rocker panel of a CJ7 is exposed on the trail, and rocks can strike it from below or from the side as the Jeep works through tight obstacles. This guard adds plate steel over that area, while the countersunk bolt holes give a flat surface for sliding over rocks.
Key features
- High strength 3/16 inch plate steel, CNC laser-cut
- Brake-formed to the CJ7 rocker lines
- Countersunk bolt holes for the flat-head hardware
- Flat surface for sliding over obstacles
- Bolts to the body and to strengthened tub sections
- Mounts to the body, so there is no gap with a body lift
Trail use and rock strikes
Rocker guards on a CJ7 earn their keep on rock-strewn trails, where the rocker is the lowest body part on the side. Angle the Jeep so obstacles meet the leading edge of the guard rather than its flat face, and avoid dragging the armor over sharp ledges that can bend the plate.
Rock strikes dent plate steel and can crack the welds if a guard takes repeated hits in one spot. After a hard trail day, look for bends, paint cracks and loose fasteners. Light dents are normal, but bent mounting points should be repaired before the armor takes another hit.
- Approach obstacles at the guard’s leading edge
- Check for bends after rock strikes
- Inspect body mounts after hard use
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 11-08-010 |
| UPC | 614901723397 |
| Type | Formed plate guard |
| Finish | Bare steel |
| Material | High strength 3/16 inch plate steel |
| Fasteners | Countersunk stainless steel flat-head, included |
| Installation | Cutting or drilling required |
Vehicle fitment
They fit the 1976 to 1986 Jeep CJ7. Compare the guard with the body of your CJ7 before the first hole is drilled. Confirm your Jeep is a CJ7 and that its year falls in that range before ordering, since a CJ5 or CJ8 uses a different guard.
Confirm your vehicle’s year, model and trim before ordering. Rubber rocker liners are sold separately.
Installation notes
Cutting or drilling is required because the guard bolts to the body. The hardware and detailed instructions are included, and the guard interfaces with the strengthened areas of the tub, such as the body mounts and strengthening ribs. The guard is brake-formed from CNC laser-cut plate, and the bolt holes are countersunk so the hardware lies flat on the surface. Because it attaches to the body, the guard is installed at the body mounts rather than on the frame.
What’s included
CJ7 rocker knockers with their countersunk stainless flat-head hardware and mounting guide.









