Overview
The Poison Spyder TJ BFH Body Mounts, part number 14-51-030, are extreme duty replacement body mounts made from 3/16 inch plate steel. They fit the Jeep Wrangler TJ and the 2004 to 2006 Jeep Wrangler LJ, Unlimited and Unlimited Rubicon. Poison Spyder designed the mounts to act as a ramp that helps the Jeep slide up and over rocks, rather than acting as an anchor that holds the vehicle back the way stock mounts can. They are meant to replace body mounts that have been damaged on the trail.
Poison Spyder designed the mounts to act as a ramp that helps the Jeep slide up and over rocks, rather than acting as an anchor that holds the vehicle back the way stock mounts can. They are meant to replace body mounts that have been damaged on the trail.
Key features
- CNC laser-cut from 3/16 inch plate steel
- Ramp-shaped profile to help the Jeep slide over rocks
- Small drain holes to keep water and mud from pooling inside
- Extreme duty replacement for damaged stock mounts
Removing and checking stock mounts
Before a new mount goes in, the old one has to come out cleanly. Support the body properly, loosen the fasteners in a planned order, and inspect the mounting area while the old part is off. Look for cracks in the frame brackets, rust that has eaten into the metal, and rubber isolators that have hardened or split. Any damage found at this stage should be repaired before the replacement is bolted in.
A replacement mount only does its job if the surface beneath it is sound and clean. Wire brush the contact points, replace stretched or corroded hardware, and make sure the new part sits flat without forcing it. Recheck the fasteners after the first few trail runs, since shifting under load can loosen them.
- Support the body before loosening fasteners
- Inspect frame brackets for cracks and rust
- Replace corroded or stretched hardware
- Recheck torque after the first trail runs
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-51-030 |
| UPC | 614901726077 |
| Type | Replacement body mount |
| Material | 3/16 inch plate steel |
| Construction | CNC laser-cut |
| Drainage | Small drain holes |
Vehicle fitment
These mounts fit the Jeep Wrangler TJ and the 2004 to 2006 Jeep Wrangler LJ, Unlimited and Unlimited Rubicon. Confirm your Jeep is a TJ or an LJ before ordering, and compare the old mounts with the new ones before removing anything.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The drain holes let water and mud run out of the mount rather than collect in it.
What’s included
One replacement body mount in CNC laser-cut 3/16 inch plate steel.
















