Overview
The Poison Spyder Customs LED 4 Pin Flasher, part number 41-04-026, is an electronic flasher that supplies the current intermittency LED taillights and turn signals need. It is made for use on a Jeep.
Once LED taillights are installed, this flasher is needed to stop the turn signal from blinking too fast.
Key features
- Electronic flasher for LED taillights and turn signals
- Four-pin connection
- Stops the fast turn signal after LED taillights are installed
- Plug and play with no soldering; instructions included
Checking the connection
A 4-pin flasher works with a circuit that uses four terminals, so start by confirming the connector shape before you begin. Compare the plug on the vehicle harness with the plug on the flasher. If they do not line up, stop and check the wiring rather than forcing the fit, because a mismatched plug can short a turn circuit.
Electronic flashers generate little heat, but they still need a solid ground and a clean power feed. Seat the connector firmly and tug it to confirm it stays put, then clip loose harness wires away from moving suspension parts. Keep the old flasher until the new one has been tested.
- Compare the plug shape with the harness before pushing it in
- Check ground and power connections
- Secure loose wires away from the suspension
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 41-04-026 |
| UPC | 614901727951 |
| Type | Electronic flasher, 4 pin |
| Application | LED taillights and turn signals |
Vehicle fitment
It fits Jeep vehicles directly. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
No soldering is needed, and the flasher is plug and play. Follow the included instructions and confirm the 4-pin connection matches your turn signal wiring.









