Overview
The Omix-Ada 12411.02 is a 2-blade flasher marked (224) for older Jeep turn signal systems. It is built to original specifications and comes with a limited five-year warranty.
It fits 1976–1993 Jeep Cherokee XJ, CJ5, CJ7, Grand Cherokee ZJ, Scrambler and Wrangler YJ, which makes it suitable for owners restoring or maintaining one of these models.
Key features
- 2-blade design marked (224)
- Built to original Omix-Ada OE specifications
- It carries a limited five-year warranty from the maker.
- Quantity per listing is a single flasher
Matching and testing the flasher
Older Jeep turn signal circuits rely on a flasher to set the blink rate, and that rate depends on the load the bulbs place on the circuit. A flasher of the wrong type can blink too fast or fail to work with the hazard switch. Keeping the same blade count and marking as the original is the simplest way to avoid a mismatch.
Good condition on the rest of the circuit matters too. Corroded sockets, cracked bulb holders and poor grounds can all make a new flasher look faulty. Clean the contacts while the old flasher is out, and check the bulbs before blaming the relay. Once the new unit is in, run the left, right and hazard signals to confirm each one flashes at a steady rate.
- Confirm the blade count matches the old unit
- Clean corroded sockets and contacts
- Test left, right and hazard after installing
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12411.02 |
| UPC | 804314025250 |
| Blade type | 2 blade |
| Marking | (224) |
| Warranty | A limited five-year warranty applies to this flasher. |
Vehicle fitment
Compatible models are the 1984–1993 Jeep Cherokee (XJ), 1976–1983 Jeep CJ5, 1976–1986 Jeep CJ7, 1993 Jeep Grand Cherokee (ZJ), 1981–1985 Jeep Scrambler and 1987–1993 Jeep Wrangler (YJ).
Years and models outside this list, including Wrangler TJ and Grand Cherokee WJ, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the 2-blade design and the (224) marking to your existing flasher before swapping it. Disconnect the battery before working on the turn signal wiring.
What’s included
One 2-blade flasher is included per listing. No connectors or other hardware are named.









