Overview
The Poison Spyder Customs LED 2 Pin Flasher, part number 41-04-262, is an electronic flasher that provides the current intermittency LED taillights and turn signals need. It is made for 1976 to 1996 Jeep CJ or YJ vehicles.
LED lights draw less current than incandescent bulbs, so a standard flasher can blink too fast. Add this flasher after LED taillights are installed to remove the fast turn signal.
Key features
- Electronic flasher for LED taillights and turn signals
- Eliminates the fast turn signal after LED taillights are installed
- Plug and play with no soldering
- Installation instructions included
Signs of a flasher problem
Flasher issues usually show up as a turn signal that blinks too fast, too slow, or not at all. With LED lights, a fast blink is often a load problem rather than a failed bulb, because the lower current draw no longer satisfies the original flasher. Check the bulbs and sockets for corrosion before blaming the flasher, since a bad ground can mimic the same symptoms.
Once a new flasher is in, test each signal side by side, including the brake lights, which share some of the same wiring on many vehicles. If the rate changes with brake use, inspect the connectors for heat damage or loose pins. Keep the wiring tidy and protected from road spray, which helps the circuit keep working over time.
- Test each side of the turn signal circuit
- Inspect connectors for heat damage
- Check grounds and bulb sockets for corrosion
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 41-04-262 |
| UPC | 614901728026 |
| Type | Electronic flasher, 2 pin |
| Application | LED taillights and turn signals |
Vehicle fitment
It is made for 1976 to 1996 Jeep CJ or YJ vehicles and is direct fit. Because it covers two models, confirm your vehicle’s year, model and trim before installing it.
Installation notes
The flasher is plug and play with no soldering, and instructions are included. Follow them, and confirm the flasher matches your turn signal circuit before installing it.
