Overview
The Rigid Industries LED flasher unit, item 40312, is a 12 volt flasher that runs Rigid LED lights in selectable flash patterns. It flashes a Rigid LED of 10 inches or smaller and is universal fit.
The flasher has 2 outputs and a waterproof housing, and it offers 7 flash patterns that the user can select.
Key features
- Flashes Rigid LEDs up to 10 inches or smaller
- Seven flash patterns
- Two outputs
- Waterproof housing
- 12 volt operation
Wiring and light selection
Wire the flasher through a fuse and a relay sized for the lights, and route the cable away from heat, moving parts and sharp edges. A switch placed where you can reach it makes it easier to turn the pattern off when the lights are not needed. Check local rules before using flashing lights on public roads, since rules on auxiliary lighting differ.
Use weatherproof connectors where wiring leaves the housing, and make a solid ground to the chassis. Inspect the cable and connectors for chafing after rough trail use, and tighten any loose terminals. A flasher that runs hot or flashes erratically should be checked before it is used again.
- Keep the ground short and clean
- Use a fuse close to the power source
Specifications
| Brand | Rigid Industries |
|---|---|
| Item number | 40312 |
| UPC | 815711010749 |
| Voltage | 12 volt |
| Outputs | 2 |
| LED size flashed | 10 inches or smaller |
| Flash patterns | 7 |
| Housing | Waterproof |
| Fitment | Universal Fit |
Vehicle fitment
It is a universal fit flasher, so it is not tied to one vehicle. Compatibility depends on the Rigid LED lights wired to it.
Installation notes
Wire the flasher through a fuse and relay sized for your lights, and check local rules before running auxiliary lighting on public roads.
What’s included
Compare the wiring and hardware you need with your installation before starting.
Not included: Rigid LED lights.









