Overview
The Poison Spyder 18-05-024 is a full corner protector in bare steel for the four-door 2007–2016 Jeep Wrangler (JK) Unlimited, including the 70th and 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X models. It covers the rear corners of the JK, which Poison Spyder describes as vulnerable on the trail.
The corners run from the rear tailgate, around the side, over the wheel openings and to the door openings. They are made from 1/8-inch steel and can be used with the stock JK fender flares or with the JK rear crusher flares. The design follows the compound curves of the JK body lines for full coverage.
The corners are tool-formed to match the JK body in a close overlay and need no cutting of the body. The only exception is clearance for light provisions, and this version has no holes for lights, so the customer drills the mounts for any lights.
The kit comes with stainless steel button head hardware and is shipped as bare steel. Installation requires drilling and threaded nut-serts. Poison Spyder supplies the nut-serts, a simple nut-sert installation tool and detailed instructions.
Key features
- Full corner coverage from the tailgate to the door opening
- Tool-formed to the JK body lines in a close-fitting overlay
- Made from 1/8-inch steel
- No holes for lights; mounts are drilled by the customer
- Stainless steel button head hardware and instructions included
- Works with the stock flares or Poison Spyder rear crusher flares
Light mounts and drilling
A full corner protector covers the rear body from the tailgate to the door opening, so the mounting layout matters more than on a small armor piece. Mark each mounting point before drilling and check the tailgate and door clearance with the corner held in place. Good fit also depends on the stock fender flares, if they are kept.
Because there are no light holes, the light mounts are the owner’s job. Plan light positions first, then confirm wiring routes and the mounting thickness before cutting. Threaded nut-serts hold the corners securely, so the holes need to be square and clean.
Steel corners rust where paint is chipped, so coat the bare steel and the cut edges after drilling. Use a good primer and touch up any scratches during routine inspections.
- Mark mounts before drilling
- Check tailgate and door clearance
- Plan light wiring before cutting
- Coat cut edges and touch up chips
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 18-05-024 |
| UPC | 614901750690 |
| Corner type | Full |
| Material | 1/8-inch steel |
| Light provisions | No holes for lights; customer drills light mounts |
| Hardware | Stainless steel button head |
| Finish | Bare steel |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
Poison Spyder lists these rear corners as a direct fit for the four-door 2007–2016 Jeep Wrangler (JK) Unlimited, including the 70th and 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X models.
They are made for the four-door 2007–2016 Jeep Wrangler JK Unlimited. Compare your year, model and trim with the fit before you buy.
Installation notes
Drilling and threaded nut-serts are required. Poison Spyder supplies the nut-serts, the installation tool and detailed instructions. Because there are no light holes, plan the light mounts before drilling the corners.
What’s included
A full set of bare steel crusher corners with stainless steel button head hardware, nut-serts and installation instructions.
Not included: the drilled light mounts, which the customer must make, and any paint or powder coating.









