Overview
The Poison Spyder 14-05-070-ALUM is a 3 inch wide rear DeFender flare with a bare aluminum finish. It is formed from 3/16 inch steel plate and is designed to match the front DeFenders.
The flare can be added to an existing set of Crusher Corners or to other full corner armor. It has a tubeless design, with a sturdy outer edge formed from 3/16 inch plate and a full under-side return for strength.
Installation involves cutting or drilling, and the flare is also intended for welding. Confirm the mounting method for your setup before fitting so the work is planned in advance.
Key features
- 3 inch wide rear flare
- Bare aluminum finish
- Formed from 3/16 inch steel plate
- Full under-side return on the outer edge
- Designed for comp cut corners
Fitting rear flares
A rear flare covers the tire and body edge behind the wheel, so its job is mostly to block mud and rock spray while giving the tire more room. Aluminum finishes look bright when new but show scratches and oxidize, so rinse the flare after trail use and touch up any bare spots that scrape through. The underside return is what gives the edge its strength, so keep it free of trapped mud that can hold moisture against the metal.
Before drilling or cutting, check the rear fender clearance against the tire and the cargo or spare tire area, and mark mounting points from the body. If you are joining the flare to corners, make sure the seam is clean and that the corners and flare overlap as a unit. Welded joints should be cleaned and treated with a rust-inhibiting primer, and bolted joints should be checked after the first few trips.
- Measure tire clearance before cutting
- Clean and prime welded seams
- Recheck fasteners after early trail use
- Inspect the flare edge for dents after rock contact
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-05-070-ALUM |
| UPC | 614901725452 |
| Position | Rear |
| Flare width | 3 inch |
| Material | 3/16 inch plate steel |
| Finish | Bare aluminum |
| Installation | Cutting or drilling required |
Vehicle fitment
It fits the 1976–1983 Jeep CJ5, the 1976–1986 Jeep CJ7, the 2004–2006 Jeep Wrangler LJ, the 1997–2006 Jeep Wrangler TJ and the 1987–1995 Jeep Wrangler YJ, across the trim lines for each model.
The list covers several generations, so confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling, which should be planned before the flare is set in place. The flare is intended to be welded, so confirm the mounting method before fitting.
What’s included
One rear DeFender flare in bare aluminum.
















