Overview
The Poison Spyder 14-02-080-V is a vented aluminum inner fender kit that installs with Poison Spyder DeFender front fenders. The inner fenders sit under the fenders and give splash protection to the engine compartment, and they give a place to mount under-hood accessories. The vented version also helps airflow through the engine bay, which Poison Spyder says helps the Jeep run cooler.
Each inner fender is a three-piece bolt-together assembly made from CNC laser cut aluminum sheet. The kit also works as a complete bolt-in DeFender installation for owners who do not have their stock inner fenders, or who would rather sell them than cut and reuse them.
No accessory mounting holes or brackets are included, so the installer decides where each component mounts. Most parts that were mounted to the stock inner fenders can be remounted on the DeFender inner fenders by drilling a hole or fabricating a simple bracket. An aftermarket air intake or an open air filter element, such as a K&N conical filter, is the practical replacement for the stock air box.
Key features
- Vented design for airflow through the engine bay
- Three-piece bolt-together aluminum assembly
- CNC laser cut aluminum sheet
- Splash protection for the engine compartment
- Complete bolt-in installation for DeFender front fenders
Under-hood layout planning
Inner fenders separate the engine bay from the wheel well, so they see road spray, mud and grit from the tire. The fasteners that hold them are exposed to vibration, so check them after rough trail runs and keep the aluminum free of standing water in the corners where it can collect.
Plan the under-hood layout before drilling any hole. Wiring, brake or washer lines and accessory brackets all need routing clear of the fender edge and the steering components at full lock. Dry-fit each piece and mark the holes with the wheel turned in both directions, then drill once the layout is confirmed.
- Mark every mounting hole with the steering at full lock
- Route harnesses away from sharp aluminum edges
- Use rubber grommets where wires pass through
- Keep the air intake path clear of the inner fender edges
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-02-080-V |
| UPC | 614901724875 |
| Material | Aluminum sheet, CNC laser cut |
| Construction | Three-piece bolt-together |
| Vent | Vented |
| Finish | Bare aluminum |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit for DeFender front fenders |
Vehicle fitment
Verify the year, model and trim against your Jeep before buying. The kit is designed to install with Poison Spyder DeFender front fenders, so confirm the fender model first.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling for any accessories moved to the new inner fenders. The air box does not have a mounting solution in this kit, so plan an aftermarket intake or open air filter before installing.
What’s included
The kit includes the vented aluminum inner fender, which is a three-piece bolt-together assembly for each side.
Not included: the Poison Spyder DeFender front fenders, which the inner fender kit requires, and any accessory mounts, brackets or air box solution.












