Overview
The Poison Spyder 15-04-020-TG-ALUM is a set of standard crusher corners in bare aluminum for the 2004–2006 Jeep Wrangler Unlimited (LJ) and Unlimited Rubicon. The corners are 3/16-inch thick and are made without hinge cut-outs.
The corners are made from high strength, lightweight 3/16-inch 6061-T6 aluminum. Poison Spyder says they provide protection from side and corner impacts, and they save up to 50 pounds compared with the company’s steel corners. They are CNC laser cut and formed to a precise fit, the same way as the steel version.
Bare aluminum takes paint, powder coat or polish, and it can stay raw. Over time, the aluminum may show only light surface oxidation. Stainless steel hardware for installation is included.
Key features
- No hinge cut-outs in the corner design
- Bare aluminum, 3/16-inch thick
- 3/16-inch 6061-T6 aluminum, CNC laser cut and formed
- Up to 50 pounds lighter than steel.
- Stainless steel hardware included
Fit checks before drilling
Drilling is the step that cannot be undone, so every fit check comes first. Hold the corners against the body with the factory tail light, the rear flares and the spare tire carrier in place. Mark the mounting holes with a fine marker and check each one for clearance behind the sheet metal.
The corners have no hinge cut-outs in their design, which keeps the rear corner panel simpler to fit. Make sure the aluminum does not rub the tub or the rear panels at full suspension flex. Check again after the first few drives, since fit can settle once the fasteners are seated.
Bare aluminum takes paint or powder coat well, and a finish applied before mounting makes the job easier. Keep fasteners and hardware sorted and clean before assembly, and replace any corroded fasteners right away.
- Mark holes before drilling
- Check tail light and spare tire clearance
- Inspect the corners after the first trail outings
- Finish the aluminum before mounting
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 15-04-020-TG-ALUM |
| UPC | 614901736359 |
| Corner type | Full, no hinge cut-outs |
| Material | 3/16-inch 6061-T6 aluminum |
| Hardware | Stainless steel |
| Finish | Bare aluminum |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
Poison Spyder lists these corners as a direct fit for the 2004–2006 Jeep Wrangler (LJ) Unlimited, including the Unlimited Rubicon.
The list does not include the 1997–2006 TJ, the 2007–2018 JK or the 2018–2022 JL. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling. Confirm the fit against your Jeep before you drill.
What’s included
A set of bare aluminum standard crusher corners with stainless steel hardware.
Not included: paint or powder coating.









