Overview
The Poison Spyder Crusher Corners (Bare Steel), part number 18-05-021, are full rear corner armor for the Jeep JK Wrangler. Made of 1/8″ steel, they protect the rear corners from the tailgate, around the side, over the wheel openings and all the way to the door openings.
Poison Spyder says its JK Crusher Corners can be used with the stock JK fender flares or with its JK Rear Crusher Flares. Instead of being brake-formed from flat steel, the corners are tool-formed to match the JK body lines in a close-fitting overlay, so no cutting of the body is needed except clearance for light provisions. The kit includes stainless steel button head hardware; drilling is required, along with installation of threaded nut-serts.
Key features
- Full-corner protection from the tailgate to the door openings
- Made of rugged 1/8″ steel, supplied as bare steel
- Tool-formed to follow the compound curves of the JK body lines
- Usable with stock JK fender flares or Poison Spyder JK Rear Crusher Flares
- Cut to accept 4″ round LED taillights and 2-1/2″ round LED back-up lights
- Complete kit with stainless steel button head hardware
- Nut-serts, a simple nut-sert installation tool and detailed instructions provided
Protecting the rear corners
Rear corner armor takes the impact from tailgate-side contact and from brush and rocks along the body. Because the steel is bare, the most useful habit is to seal it early. Paint the corners before fitting, or coat them right after, and give cut and drilled edges a fresh coat as well, since those spots are where rust usually begins.
Corner armor changes how the rear body sits in the wheel openings, so check clearance at full suspension compression and with the tailgate fully opened. Recheck the nut-serts after rough use, since they carry the load of the armor. Keep the light wiring away from the armor edges so heat and flex do not damage the insulation.
- Check tailgate swing after installation
- Inspect nut-serts after rough trail use
- Keep light wiring clear of sharp edges
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 18-05-021 |
| UPC | 614901750676 |
| Product type | Rear corner armor (Crusher Corners) |
| Corner type | Full |
| Finish | Bare steel |
| Material | 1/8″ steel |
| Light cutouts | 4″ round LED taillights; 2-1/2″ round LED back-up lights (lights sold separately) |
| Hardware | Stainless steel button head hardware |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
The Crusher Corners fit the Jeep Wrangler JK, model years 2007–2018. Other Wrangler generations, such as the TJ and JL, are not covered.
Other Wrangler generations, such as the TJ and JL, are not covered. The LED lights are sold separately. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Support the vehicle on jack stands or a lift on level ground, never on a jack alone. Tighten all fasteners to the correct torque for your vehicle, and re-check them after the first miles of driving.
Drilling is required and threaded nut-serts must be installed. Use the supplied nut-sert tool and follow the included instructions.
Bare steel will rust if left unprotected, so plan to paint or coat the corners and any cut or drilled edges after fitting.
Check your local regulations on taillight and back-up light placement when fitting the light cutouts.
What’s included
The Crusher Corners kit includes stainless steel button head hardware, nut-serts, a nut-sert installation tool and detailed instructions.
Not included: 4″ round LED taillights and 2-1/2″ round LED back-up lights, which are sold separately, and paint or coating for the bare steel.








