Overview
These rear crusher flares replace the original plastic rear flares on the 2007–2018 Jeep Wrangler JK, in both 2-door and 4-door models. They are built from steel for rough terrain, where factory plastic flares can tear off or be damaged.
Each flare gives tire coverage for tires up to 40 inches. The mounting plate is CNC laser cut from 3/16-inch plate steel and brake formed to the flare mounting surface. The rails are CNC bent 1.5 by .120-wall DOM structural tubing, and the fender surface is 1/8-inch laser cut plate steel. Rear crusher flares come with a 4-piece inner brace kit, which Poison Spyder says keeps the flares from deforming the Jeep’s outer tub sheet metal on impacts.
Key features
- All-steel construction in place of plastic factory flares
- Tire coverage for tires up to 40 inches
- 3 inches wide
- Stainless steel countersunk flat head cap screws for mounting
- 4-piece inner brace kit included with the rear flares
- Black powder coat finish
Tire clearance and fender work
Rear flares define how much tire can sit under the body without rubbing. A steel flare with a fender surface gives a fixed edge, so tire size and wheel offset decide how much room is left. Before drilling, mount the tire you plan to run and check for rub at full steering lock and on compression.
Fender work on a JK is more involved than bolting on a panel. Inner sheet metal may need minor trimming, and the nut-serts must be set square to hold. Plan the drill locations, mark them carefully, and check the fit again before the holes are made. Wiring and fuel lines behind the fender should be moved or protected first.
- Test tire rub at full steering lock
- Mark drill holes before cutting
- Protect wiring and lines behind the fender
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 17-05-010P1 |
| UPC | 614901751567 |
| Position | Rear fender |
| Width | 3 inches |
| Tire coverage | Up to 40 inches |
| Mounting plate | 3/16-inch CNC laser cut plate steel |
| Rails | 1.5 by .120-wall DOM structural tubing |
| Fender surface | 1/8-inch laser cut plate steel |
| Mounting hardware | Stainless steel countersunk flat head cap screws |
| Inner brace kit | 4-piece |
| Finish | Black powder coat |
Vehicle fitment
Poison Spyder lists these flares for the Jeep JK, the Wrangler (JK) generation sold from 2007 to 2018, in 2-door and 4-door models.
The flares are made for the JK generation only. Earlier Wrangler models (TJ and LJ) and the JL generation are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires drilling and the nut-sert fasteners that come with the flares, and Poison Spyder supplies a nut-sert installation tool to set them. Tire clearance may require minor trimming of the inner sheet metal. Drilling the mounting holes is permanent, so check the fit and mark the holes before drilling.
What’s included
Each order includes a pair of rear crusher flares, the 4-piece inner brace kit and the nut-sert installation tool.













