Overview
The Poison Spyder 17-03-030P1 is a standard width steel front crusher flare in a black powder coat finish, made for the Jeep Wrangler JK in two-door and four-door models. The flares are sold as a pair. They are built to cover the thin plastic factory flares and the sheet metal that holds them, with steel plate.
The outer rub rail is 1.5 inch x .120 wall DOM structural tubing, which Poison Spyder says resists crushing, kinking and bending better than the thinner welded seam tubing on many competing flares. The foundation is a CNC laser cut 3/16-inch steel mounting plate, brake-formed to match the curves of the JK body panels. The top plate is 1/8-inch aluminum that is hand formed around the flare to follow the body lines.
Each set comes with a set of inner braces that tie the flare to the heavier gauge steel of the JK inner body tub. Poison Spyder explains that other JK flares bolt only to the outer sheet metal, which is thin and flexible, and can deform under a rock strike. The inner braces send those forces to the stronger inner structure instead. The braces are CNC laser cut and brake-formed for a precise fit.
The mounting holes are countersunk for flat-head stainless steel hardware. The attachment system is designed to carry impacts into the inner structure rather than the thin outer sheet metal.
Key features
- Black powder coat finish on a standard width steel flare
- 1.5 inch x .120 wall DOM structural tubing outer rub rail
- 3/16-inch CNC laser cut steel mounting plate
- 1/8-inch aluminum top plate, hand formed to the body lines
- Inner brace set for each flare
- Countersunk holes for flat-head stainless steel hardware
Caring for powder coat finish
Black powder coat protects steel from the weather and from light scrapes, but it is still a coating. After fitting, check the edges and the countersunk holes for chips, since bare metal at those spots can start rust. Wash the flares with mild soap and water rather than harsh solvents, and avoid pressure washing directly at the seams.
Trail use puts stones and branches against the flares, so inspection after each outing helps. Look at the mounting plate where it meets the body and at the inner braces for loose hardware. Tightening the bolts and touching up small chips with matching touch-up paint keeps the finish and the mounts in good condition.
- Inspect edges after rough trail days
- Use matching touch-up paint for small chips
- Keep the inner brace bolts snug
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 17-03-030P1 |
| UPC | 614901751550 |
| Location | Front |
| Type | Fender |
| Width | Standard |
| Outer rub rail | 1.5 inch x .120 wall DOM structural tubing |
| Mounting plate | 3/16-inch steel |
| Top plate | 1/8-inch aluminum |
| Quantity | Sold as a pair |
| Finish | Black powder coat |
| Installation type | No cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
These standard width steel front flares are made for the Jeep Wrangler JK, which covers the 2007–2018 model years in two-door and four-door bodies.
The design covers only the Jeep Wrangler JK, so TJ, LJ and JL models are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
No cutting or drilling is needed for installation. Fit the inner brace set with each flare so the impact load reaches the inner tub, and check the powder coat for chips or damage before mounting.
What’s included
A pair of black powder coat standard width steel front crusher flares with their mounting plates, top plates and inner brace sets.














