Overview
The Poison Spyder Brawler front bumper for 2-door Jeep Wrangler JK models is a mid-width, high clearance bumper in bare 3/16″ plate steel. It has an integrated winch mount, an integrated 2″ receiver and provisions for mounting recessed backup lamps.
JK Rocker Knockers protect the rocker panels, which are the most exposed part of the JK body. They attach in 14 bolt locations, use a 1.75″ X .120 wall DOM rocker rail and a CNC laser-cut slider skid, and mount to the body tub, so they lift with a body lift. The Brawler Lite bumper has ends long enough to protect the lower corner of the JK grille without hindering tire clearance. It mounts without cutting or altering the frame rails, and the factory Crash Bar can be kept or removed.
If the Crash Bar stays, Poison Spyder recommends the Brawler Lite Skid Plate, which is available separately and conceals the bar while protecting the electronic sway bar disconnect.
Key features
- Mid-width, high clearance bumper in 3/16″ plate steel
- Integrated winch mount
- Integrated 2″ receiver
- Provisions for recessed backup lamps
- Rocker Knockers fasten to the body at 14 bolt locations
- Slider skid attaches with countersunk stainless steel flat head cap screws
- Rocker Knockers include drain reliefs so debris does not collect in the lower body cavity
Rocker and body protection
Rocker panels sit low on a Jeep and take hits from rocks, stumps and ledges, so protecting them is a common reason to add side armor. Rocker protection works best when the mounting points are solid and the slider skid can absorb a hit without passing the force into the body.
Body lifts change how side protection sits. Components that mount to the body tub move with the lift, so check clearance at the tire and fender edge after installing any lift. Keep drain openings clear so water and mud do not collect inside the rocker cavity.
If you plan to paint or powder coat the steel, clean and prime the surface before installation, paying attention to the bolt holes. Skids wear over time, and a worn skid should be replaced before the underlying steel is exposed to rust.
- Check body-mount bolts after rough trails
- Clear drain openings of mud and debris
- Recheck clearance after any body lift
- Replace worn skids before rust starts
Specifications
| Brand | Poison Spyder |
|---|---|
| UPC | 700007616841 |
| Type | Front bumper for JK, 2-door models |
| Material | 3/16″ plate steel |
| Finish | Bare steel |
| Width | Mid-width, high clearance |
| Winch mount | Integrated |
| Receiver | Integrated, 2″ |
| Rocker rail tubing | 1.75″ X .120 wall DOM |
| Outer skid | 1/8″ steel on a 3/16″ base plate |
| Body styles | 2-door |
Vehicle fitment
It is written for the Jeep Wrangler JK, 2007-2018, and it fits 2-door models.
The 4-door JK uses a different part, and other Wrangler generations are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The Rocker Knocker slider skid can be removed and replaced if it is damaged, and the slider does not depend on the skid for structure. Poison Spyder says Rocker Knockers can be used alone or alongside its JK Body Armor. The metal is bare steel and needs paint or powder coat.
What’s included
- Front bumper with integrated winch mount and 2″ receiver
Not included: a winch, fairlead and paint or powder coat.
























