Overview
The Omix-ADA 18052.07 is a front tie rod assembly for the 1991-2001 Jeep Cherokee (XJ). It is listed with the Base, Briarwood, Classic, Country, Laredo, Limited, SE and Sport trims.
It is a direct OE replacement built to original specifications.
Key features
- Front position
- Direct fit listing for the XJ generation
- Direct OE replacement built to original specifications
- Limited five year warranty.
Front toe and steering wear
A front tie rod assembly carries steering input from the rack to the wheel, so wear at its ends is felt as slop in the steering and as tires scrubbing on one side. The XJ front end sees a lot of gravel and water on trails, which makes boot damage common. Checking the ends for play by hand with the vehicle safely supported is a quick way to decide whether a replacement is due.
Because the assembly sets the toe, any replacement changes the front alignment. Mark the position of adjusting parts before loosening them so the setting is close, then have a full alignment done. A worn assembly can also load the steering box and related joints, so the rest of the linkage deserves a look while the front end is apart.
- Play at the ends with the wheel off the ground
- Boot damage and loose clamps
- Uneven inside tire wear
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18052.07 |
| UPC | 804314137533 |
| Position | Front |
| Fitment type | Direct fit |
| Warranty | Limited five year warranty. |
Vehicle fitment
It fits the 1991-2001 Jeep Cherokee (XJ) in Base, Briarwood, Classic, Country, Laredo, Limited, SE and Sport trims.
Grand Cherokee (WJ) and Wrangler (YJ) models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Alignment should be checked once the assembly is installed, since toe changes when a tie rod is replaced.
What’s included
One tie rod assembly, part number 18052.07.









