Overview
It is an inner tie rod end for the 2011-2013 Jeep Grand Cherokee (WK). It fits the Laredo, Limited, Overland, Overland Summit and SRT8 trims.
Inner tie rod ends can rust or weaken with age, and a worn one affects steering alignment and can wear tires unevenly. Omix-ADA offers this inner end as a replacement for that wear.
Key features
- Inner position
- Replacement for a rusted or weakened inner tie rod end
- Direct fit listing for the WK generation
- Trims listed: Laredo, Limited, Overland, Overland Summit and SRT8
Signs of a worn inner joint
The inner tie rod end sits on the rack side of the steering linkage and is out of sight behind the front wheel. Wear there often shows up as a clicking or knocking through the steering when the wheel is turned at low speed, or as a loose feel near the center of the wheel. Rust on the joint and a torn boot are common causes, and the rack boot should be checked at the same time.
When replacing an inner end, measure the old one and compare it before fitting the new piece. The inner end sets the toe along with the outer end, so alignment is needed after the job. Uneven tire wear on the inside or outside edge can also point to a joint that has worn beyond its limit, so it is worth checking both sides.
- Clicking or knocking through the steering
- Torn rack boot or grease on the linkage
- Rust on the joint housing
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18043.18 |
| UPC | 804314267520 |
| Position | Inner |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2011-2013 Jeep Grand Cherokee (WK) in the Laredo, Limited, Overland, Overland Summit and SRT8 trims.
The list covers the WK generation only, so earlier Grand Cherokee models such as the WJ are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Since this is an inner end, have the toe and alignment checked after the replacement is complete.
What’s included
One inner tie rod end, part number 18043.18.












