Overview
It is a front left outer tie rod end with a left hand thread and a 3/4 inch thread size. It fits the 1956-1957 Jeep Utility Wagon (Base) and the 1950-1952 and 1954-1957 Jeep Willys CJ-3 (Chassis).
It is a direct fit and an OE replacement for the front left outer position. Because the thread runs left hand, the new end must match the thread direction of the one it replaces.
Key features
- Left hand thread, 3/4 inch
- Front left outer position
- Direct fit OE replacement from Omix-ADA
- Limited five year warranty.
Choosing and fitting a replacement end
A tie rod end connects the steering linkage to the front wheel, so wear at the joint shows up as looseness in the steering wheel, a wandering feel on the road and uneven wear on the inside edge of the tire. On older Jeep models, the rubber boot and grease fitting are often the first parts to fail, and a dry joint wears quickly once dirt gets in. Inspect the drag link and the opposite side’s tie rod at the same time, since they carry the same load and are commonly replaced in the same job.
Because the thread direction matters, take the old end to the parts counter or measure it before buying. Keep the jam nut and clamp in good condition, and replace the cotter pin or nut hardware when it is disturbed. Once the new end is in, have the toe set by an alignment shop, then recheck the joint after the first few drives.
- Look for play when the front wheel is raised
- Check the boot for cracks or grease loss
- Replace worn cotter pins and nuts during the job
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18043.01 |
| UPC | 804314014278 |
| Position | Front left outer |
| Thread direction | Left hand |
| Thread size | 3/4 inch |
| Fitment type | Direct fit |
| Warranty | Limited five year warranty. |
Vehicle fitment
It fits the 1956-1957 Jeep Utility Wagon (Base) and the 1950-1952 and 1954-1957 Jeep Willys CJ-3 (Chassis).
Other CJ models, including the CJ-5 and CJ-7, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the left hand thread matches the removed part, then have the front alignment checked.
What’s included
One tie rod end, part number 18043.01.









